Merge branch 'for-2.6.37/drivers' into for-linus

Conflicts:
	drivers/block/cciss.c

Signed-off-by: Jens Axboe <jaxboe@fusionio.com>

1 files changed, 59 insertions, 69 deletions

diff --git a/drivers/block/cciss.c b/drivers/block/cciss.c
index 2cdbc247d0a..a67d0a611a8 100644
--- a/drivers/block/cciss.c
+++ b/drivers/block/cciss.c
@@ -113,6 +113,8 @@ static struct board_type products[] = {
         {0x409D0E11, "Smart Array 6400 EM", &SA5_access},
         {0x40910E11, "Smart Array 6i", &SA5_access},
         {0x3225103C, "Smart Array P600", &SA5_access},
+        {0x3223103C, "Smart Array P800", &SA5_access},
+        {0x3234103C, "Smart Array P400", &SA5_access},
         {0x3235103C, "Smart Array P400i", &SA5_access},
         {0x3211103C, "Smart Array E200i", &SA5_access},
         {0x3212103C, "Smart Array E200", &SA5_access},
@@ -3753,7 +3755,7 @@ static void __devinit cciss_wait_for_mode_change_ack(ctlr_info_t *h)
         for (i = 0; i < MAX_CONFIG_WAIT; i++) {
                 if (!(readl(h->vaddr + SA5_DOORBELL) & CFGTBL_ChangeReq))
                         break;
-                msleep(10);
+                usleep_range(10000, 20000);
         }
 }
 
@@ -3937,10 +3939,9 @@ static int __devinit cciss_lookup_board_id(struct pci_dev *pdev, u32 *board_id)
         *board_id = ((subsystem_device_id << 16) & 0xffff0000) |
                         subsystem_vendor_id;
 
-        for (i = 0; i < ARRAY_SIZE(products); i++) {
+        for (i = 0; i < ARRAY_SIZE(products); i++)
                 if (*board_id == products[i].board_id)
                         return i;
-        }
         dev_warn(&pdev->dev, "unrecognized board ID: 0x%08x, ignoring.\n",
                 *board_id);
         return -ENODEV;
@@ -3971,18 +3972,31 @@ static int __devinit cciss_pci_find_memory_BAR(struct pci_dev *pdev,
         return -ENODEV;
 }
 
-static int __devinit cciss_wait_for_board_ready(ctlr_info_t *h)
+static int __devinit cciss_wait_for_board_state(struct pci_dev *pdev,
+        void __iomem *vaddr, int wait_for_ready)
+#define BOARD_READY 1
+#define BOARD_NOT_READY 0
 {
-        int i;
+        int i, iterations;
         u32 scratchpad;
 
-        for (i = 0; i < CCISS_BOARD_READY_ITERATIONS; i++) {
-                scratchpad = readl(h->vaddr + SA5_SCRATCHPAD_OFFSET);
-                if (scratchpad == CCISS_FIRMWARE_READY)
-                        return 0;
+        if (wait_for_ready)
+                iterations = CCISS_BOARD_READY_ITERATIONS;
+        else
+                iterations = CCISS_BOARD_NOT_READY_ITERATIONS;
+
+        for (i = 0; i < iterations; i++) {
+                scratchpad = readl(vaddr + SA5_SCRATCHPAD_OFFSET);
+                if (wait_for_ready) {
+                        if (scratchpad == CCISS_FIRMWARE_READY)
+                                return 0;
+                } else {
+                        if (scratchpad != CCISS_FIRMWARE_READY)
+                                return 0;
+                }
                 msleep(CCISS_BOARD_READY_POLL_INTERVAL_MSECS);
         }
-        dev_warn(&h->pdev->dev, "board not ready, timed out.\n");
+        dev_warn(&pdev->dev, "board not ready, timed out.\n");
         return -ENODEV;
 }
 
@@ -4031,6 +4045,11 @@ static int __devinit cciss_find_cfgtables(ctlr_info_t *h)
 static void __devinit cciss_get_max_perf_mode_cmds(struct ctlr_info *h)
 {
         h->max_commands = readl(&(h->cfgtable->MaxPerformantModeCommands));
+
+        /* Limit commands in memory limited kdump scenario. */
+        if (reset_devices && h->max_commands > 32)
+                h->max_commands = 32;
+
         if (h->max_commands < 16) {
                 dev_warn(&h->pdev->dev, "Controller reports "
                         "max supported commands of %d, an obvious lie. "
@@ -4148,7 +4167,7 @@ static int __devinit cciss_pci_init(ctlr_info_t *h)
                 err = -ENOMEM;
                 goto err_out_free_res;
         }
-        err = cciss_wait_for_board_ready(h);
+        err = cciss_wait_for_board_state(h->pdev, h->vaddr, BOARD_READY);
         if (err)
                 goto err_out_free_res;
         err = cciss_find_cfgtables(h);
@@ -4313,36 +4332,6 @@ static __devinit int cciss_message(struct pci_dev *pdev, unsigned char opcode, u
 #define cciss_soft_reset_controller(p) cciss_message(p, 1, 0)
 #define cciss_noop(p) cciss_message(p, 3, 0)
 
-static __devinit int cciss_reset_msi(struct pci_dev *pdev)
-{
-/* the #defines are stolen from drivers/pci/msi.h. */
-#define msi_control_reg(base)           (base + PCI_MSI_FLAGS)
-#define PCI_MSIX_FLAGS_ENABLE           (1 << 15)
-
-        int pos;
-        u16 control = 0;
-
-        pos = pci_find_capability(pdev, PCI_CAP_ID_MSI);
-        if (pos) {
-                pci_read_config_word(pdev, msi_control_reg(pos), &control);
-                if (control & PCI_MSI_FLAGS_ENABLE) {
-                        dev_info(&pdev->dev, "resetting MSI\n");
-                        pci_write_config_word(pdev, msi_control_reg(pos), control & ~PCI_MSI_FLAGS_ENABLE);
-                }
-        }
-
-        pos = pci_find_capability(pdev, PCI_CAP_ID_MSIX);
-        if (pos) {
-                pci_read_config_word(pdev, msi_control_reg(pos), &control);
-                if (control & PCI_MSIX_FLAGS_ENABLE) {
-                        dev_info(&pdev->dev, "resetting MSI-X\n");
-                        pci_write_config_word(pdev, msi_control_reg(pos), control & ~PCI_MSIX_FLAGS_ENABLE);
-                }
-        }
-
-        return 0;
-}
-
 static int cciss_controller_hard_reset(struct pci_dev *pdev,
         void * __iomem vaddr, bool use_doorbell)
 {
@@ -4397,17 +4386,17 @@ static int cciss_controller_hard_reset(struct pci_dev *pdev,
  * states or using the doorbell register. */
 static __devinit int cciss_kdump_hard_reset_controller(struct pci_dev *pdev)
 {
-        u16 saved_config_space[32];
         u64 cfg_offset;
         u32 cfg_base_addr;
         u64 cfg_base_addr_index;
         void __iomem *vaddr;
         unsigned long paddr;
         u32 misc_fw_support, active_transport;
-        int rc, i;
+        int rc;
         CfgTable_struct __iomem *cfgtable;
         bool use_doorbell;
         u32 board_id;
+        u16 command_register;
 
         /* For controllers as old a the p600, this is very nearly
          * the same thing as
@@ -4417,14 +4406,6 @@ static __devinit int cciss_kdump_hard_reset_controller(struct pci_dev *pdev)
          * pci_set_power_state(pci_dev, PCI_D0);
          * pci_restore_state(pci_dev);
          *
-         * but we can't use these nice canned kernel routines on
-         * kexec, because they also check the MSI/MSI-X state in PCI
-         * configuration space and do the wrong thing when it is
-         * set/cleared.  Also, the pci_save/restore_state functions
-         * violate the ordering requirements for restoring the
-         * configuration space from the CCISS document (see the
-         * comment below).  So we roll our own ....
-         *
          * For controllers newer than the P600, the pci power state
          * method of resetting doesn't work so we have another way
          * using the doorbell register.
@@ -4443,8 +4424,13 @@ static __devinit int cciss_kdump_hard_reset_controller(struct pci_dev *pdev)
                 return -ENODEV;
         }
 
-        for (i = 0; i < 32; i++)
-                pci_read_config_word(pdev, 2*i, &saved_config_space[i]);
+        /* Save the PCI command register */
+        pci_read_config_word(pdev, 4, &command_register);
+        /* Turn the board off.  This is so that later pci_restore_state()
+         * won't turn the board on before the rest of config space is ready.
+         */
+        pci_disable_device(pdev);
+        pci_save_state(pdev);
 
         /* find the first memory BAR, so we can find the cfg table */
         rc = cciss_pci_find_memory_BAR(pdev, &paddr);
@@ -4479,26 +4465,32 @@ static __devinit int cciss_kdump_hard_reset_controller(struct pci_dev *pdev)
         rc = cciss_controller_hard_reset(pdev, vaddr, use_doorbell);
         if (rc)
                 goto unmap_cfgtable;
-
-        /* Restore the PCI configuration space.  The Open CISS
-         * Specification says, "Restore the PCI Configuration
-         * Registers, offsets 00h through 60h. It is important to
-         * restore the command register, 16-bits at offset 04h,
-         * last. Do not restore the configuration status register,
-         * 16-bits at offset 06h."  Note that the offset is 2*i.
-         */
-        for (i = 0; i < 32; i++) {
-                if (i == 2 || i == 3)
-                        continue;
-                pci_write_config_word(pdev, 2*i, saved_config_space[i]);
+        pci_restore_state(pdev);
+        rc = pci_enable_device(pdev);
+        if (rc) {
+                dev_warn(&pdev->dev, "failed to enable device.\n");
+                goto unmap_cfgtable;
         }
-        wmb();
-        pci_write_config_word(pdev, 4, saved_config_space[2]);
+        pci_write_config_word(pdev, 4, command_register);
 
         /* Some devices (notably the HP Smart Array 5i Controller)
            need a little pause here */
         msleep(CCISS_POST_RESET_PAUSE_MSECS);
 
+        /* Wait for board to become not ready, then ready. */
+        dev_info(&pdev->dev, "Waiting for board to become ready.\n");
+        rc = cciss_wait_for_board_state(pdev, vaddr, BOARD_NOT_READY);
+        if (rc) /* Don't bail, might be E500, etc. which can't be reset */
+                dev_warn(&pdev->dev,
+                        "failed waiting for board to become not ready\n");
+        rc = cciss_wait_for_board_state(pdev, vaddr, BOARD_READY);
+        if (rc) {
+                dev_warn(&pdev->dev,
+                        "failed waiting for board to become ready\n");
+                goto unmap_cfgtable;
+        }
+        dev_info(&pdev->dev, "board ready.\n");
+
         /* Controller should be in simple mode at this point.  If it's not,
          * It means we're on one of those controllers which doesn't support
          * the doorbell reset method and on which the PCI power management reset
@@ -4539,8 +4531,6 @@ static __devinit int cciss_init_reset_devices(struct pci_dev *pdev)
                 return 0; /* just try to do the kdump anyhow. */
         if (rc)
                 return -ENODEV;
-        if (cciss_reset_msi(pdev))
-                return -ENODEV;
 
         /* Now try to get the controller to respond to a no-op */
         for (i = 0; i < CCISS_POST_RESET_NOOP_RETRIES; i++) {