aboutsummaryrefslogtreecommitdiffstats
path: root/arch/powerpc/boot/dts/gef_sbc610.dts
Commit message (Expand)AuthorAge
* dt/bindings: Remove all references to device_type "ethernet-phy"Grant Likely2014-01-16
* powerpc/fsl: update compatiable on fsl 16550 uart nodesKumar Gala2012-01-04
* powerpc/86xx: Correct Gianfar support for GE boardsMartyn Welch2011-11-03
* powerpc/86xx: Renaming following split of GE Fanuc joint ventureMartyn Welch2010-03-04
* powerpc/86xx: Basic flash support for GE SBC610Martyn Welch2010-02-17
* powerpc/86xx: Add MSI section to GE SBC610 DTSMalcolm Crossley2010-02-17
* powerpc/86xx: Enable NVRAM on GE Fanuc's SBC610Martyn Welch2009-11-20
* powerpc/86xx: Add I2C device mappings in DTS for SBC610Martyn Welch2009-06-15
* powerpc/fsl: Removed reg property from 85xx/86xx soc nodeKumar Gala2009-05-19
* powerpc/86xx: Add new LAW & MCM device tree nodes for all 86xx systemsKumar Gala2009-05-19
* powerpc/86xx: Move gianfar mdio nodes under the ethernet nodesAnton Vorontsov2009-03-24
* powerpc/86xx: Correct local bus registers in GE Fanuc SBC610 dts fileMartyn Welch2009-03-09
* [WATCHDOG] Enable watchdog timer on GE Fanuc's SBC610Martyn Welch2009-01-12
* powerpc/86xx: Basic GPIO support for GE Fanuc SBC610Martyn Welch2008-12-03
* powerpc/86xx: Add use of Epson RTX-8581 RTC to GE Fanuc SBC610 dtsMartyn Welch2008-12-03
* powerpc/86xx: Correct SOC bus-frequency in GE Fanuc SBC610 DTSMartyn Welch2008-11-08
* powerpc: FPGA support for GE Fanuc SBC610Martyn Welch2008-10-13
* powerpc: GE Fanuc's FPGA based PIC controller on the SBC610Martyn Welch2008-10-13
* powerpc: Board support for GE Fanuc SBC610Martyn Welch2008-09-16
generated by cgit v1.2.2 (git 2.25.0) at 2024-11-21 18:30:28 -0500