1 files changed, 5 insertions, 6 deletions

diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index 7f256e23c57f..20d372edec29 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -147,6 +147,8 @@ struct ieee80211_low_level_stats {
  * @BSS_CHANGED_CQM: Connection quality monitor config changed
  * @BSS_CHANGED_IBSS: IBSS join status changed
  * @BSS_CHANGED_ARP_FILTER: Hardware ARP filter address list or state changed.
+ * @BSS_CHANGED_QOS: QoS for this association was enabled/disabled. Note
+ *      that it is only ever disabled for station mode.
  */
 enum ieee80211_bss_change {
         BSS_CHANGED_ASSOC               = 1<<0,
@@ -162,6 +164,7 @@ enum ieee80211_bss_change {
         BSS_CHANGED_CQM                 = 1<<10,
         BSS_CHANGED_IBSS                = 1<<11,
         BSS_CHANGED_ARP_FILTER          = 1<<12,
+        BSS_CHANGED_QOS                 = 1<<13,
 
         /* when adding here, make sure to change ieee80211_reconfig */
 };
@@ -217,6 +220,7 @@ enum ieee80211_bss_change {
  *      filter ARP queries based on the @arp_addr_list, if disabled, the
  *      hardware must not perform any ARP filtering. Note, that the filter will
  *      be enabled also in promiscuous mode.
+ * @qos: This is a QoS-enabled BSS.
  */
 struct ieee80211_bss_conf {
         const u8 *bssid;
@@ -240,6 +244,7 @@ struct ieee80211_bss_conf {
         __be32 arp_addr_list[IEEE80211_BSS_ARP_ADDR_LIST_LEN];
         u8 arp_addr_cnt;
         bool arp_filter_enabled;
+        bool qos;
 };
 
 /**
@@ -620,15 +625,11 @@ struct ieee80211_rx_status {
  *      may turn the device off as much as possible. Typically, this flag will
  *      be set when an interface is set UP but not associated or scanning, but
  *      it can also be unset in that case when monitor interfaces are active.
- * @IEEE80211_CONF_QOS: Enable 802.11e QoS also know as WMM (Wireless
- *      Multimedia). On some drivers (iwlwifi is one of know) we have
- *      to enable/disable QoS explicitly.
  */
 enum ieee80211_conf_flags {
         IEEE80211_CONF_MONITOR          = (1<<0),
         IEEE80211_CONF_PS               = (1<<1),
         IEEE80211_CONF_IDLE             = (1<<2),
-        IEEE80211_CONF_QOS              = (1<<3),
 };
 
 
@@ -643,7 +644,6 @@ enum ieee80211_conf_flags {
  * @IEEE80211_CONF_CHANGE_RETRY_LIMITS: retry limits changed
  * @IEEE80211_CONF_CHANGE_IDLE: Idle flag changed
  * @IEEE80211_CONF_CHANGE_SMPS: Spatial multiplexing powersave mode changed
- * @IEEE80211_CONF_CHANGE_QOS: Quality of service was enabled or disabled
  */
 enum ieee80211_conf_changed {
         IEEE80211_CONF_CHANGE_SMPS              = BIT(1),
@@ -654,7 +654,6 @@ enum ieee80211_conf_changed {
         IEEE80211_CONF_CHANGE_CHANNEL           = BIT(6),
         IEEE80211_CONF_CHANGE_RETRY_LIMITS      = BIT(7),
         IEEE80211_CONF_CHANGE_IDLE              = BIT(8),
-        IEEE80211_CONF_CHANGE_QOS               = BIT(9),
 };
 
 /**