1 files changed, 28 insertions, 0 deletions

diff --git a/include/uapi/linux/nl80211.h b/include/uapi/linux/nl80211.h
index 29c4399e08b9..e5b8caf5e466 100644
--- a/include/uapi/linux/nl80211.h
+++ b/include/uapi/linux/nl80211.h
@@ -722,6 +722,22 @@
  *      QoS mapping is relevant for IP packets, it is only valid during an
  *      association. This is cleared on disassociation and AP restart.
  *
+ * @NL80211_CMD_ADD_TX_TS: Ask the kernel to add a traffic stream for the given
+ *      %NL80211_ATTR_TSID and %NL80211_ATTR_MAC with %NL80211_ATTR_USER_PRIO
+ *      and %NL80211_ATTR_ADMITTED_TIME parameters.
+ *      Note that the action frame handshake with the AP shall be handled by
+ *      userspace via the normal management RX/TX framework, this only sets
+ *      up the TX TS in the driver/device.
+ *      If the admitted time attribute is not added then the request just checks
+ *      if a subsequent setup could be successful, the intent is to use this to
+ *      avoid setting up a session with the AP when local restrictions would
+ *      make that impossible. However, the subsequent "real" setup may still
+ *      fail even if the check was successful.
+ * @NL80211_CMD_DEL_TX_TS: Remove an existing TS with the %NL80211_ATTR_TSID
+ *      and %NL80211_ATTR_MAC parameters. It isn't necessary to call this
+ *      before removing a station entry entirely, or before disassociating
+ *      or similar, cleanup will happen in the driver/device in this case.
+ *
  * @NL80211_CMD_MAX: highest used command number
  * @__NL80211_CMD_AFTER_LAST: internal use
  */
@@ -893,6 +909,9 @@ enum nl80211_commands {
 
         NL80211_CMD_SET_QOS_MAP,
 
+        NL80211_CMD_ADD_TX_TS,
+        NL80211_CMD_DEL_TX_TS,
+
         /* add new commands above here */
 
         /* used to define NL80211_CMD_MAX below */
@@ -1611,6 +1630,11 @@ enum nl80211_commands {
  *      drivers to indicate dynack capability. Dynack is automatically disabled
  *      setting valid value for coverage class.
  *
+ * @NL80211_ATTR_TSID: a TSID value (u8 attribute)
+ * @NL80211_ATTR_USER_PRIO: user priority value (u8 attribute)
+ * @NL80211_ATTR_ADMITTED_TIME: admitted time in units of 32 microseconds
+ *      (per second) (u16 attribute)
+ *
  * @NL80211_ATTR_MAX: highest attribute number currently defined
  * @__NL80211_ATTR_AFTER_LAST: internal use
  */
@@ -1957,6 +1981,10 @@ enum nl80211_attrs {
 
         NL80211_ATTR_WIPHY_DYN_ACK,
 
+        NL80211_ATTR_TSID,
+        NL80211_ATTR_USER_PRIO,
+        NL80211_ATTR_ADMITTED_TIME,
+
         /* add attributes here, update the policy in nl80211.c */
 
         __NL80211_ATTR_AFTER_LAST,