1 files changed, 234 insertions, 0 deletions

diff --git a/include/linux/wimax.h b/include/linux/wimax.h
new file mode 100644
index 000000000000..c89de7f4e5b9
--- /dev/null
+++ b/include/linux/wimax.h
@@ -0,0 +1,234 @@
+/*
+ * Linux WiMax
+ * API for user space
+ *
+ *
+ * Copyright (C) 2007-2008 Intel Corporation. All rights reserved.
+ *
+ * Redistribution and use in source and binary forms, with or without
+ * modification, are permitted provided that the following conditions
+ * are met:
+ *
+ *   * Redistributions of source code must retain the above copyright
+ *     notice, this list of conditions and the following disclaimer.
+ *   * Redistributions in binary form must reproduce the above copyright
+ *     notice, this list of conditions and the following disclaimer in
+ *     the documentation and/or other materials provided with the
+ *     distribution.
+ *   * Neither the name of Intel Corporation nor the names of its
+ *     contributors may be used to endorse or promote products derived
+ *     from this software without specific prior written permission.
+ *
+ * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
+ * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
+ * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
+ * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
+ * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
+ * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
+ * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
+ * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
+ * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
+ * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
+ * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+ *
+ *
+ * Intel Corporation <linux-wimax@intel.com>
+ * Inaky Perez-Gonzalez <inaky.perez-gonzalez@intel.com>
+ *  - Initial implementation
+ *
+ *
+ * This file declares the user/kernel protocol that is spoken over
+ * Generic Netlink, as well as any type declaration that is to be used
+ * by kernel and user space.
+ *
+ * It is intended for user space to clone it verbatim to use it as a
+ * primary reference for definitions.
+ *
+ * Stuff intended for kernel usage as well as full protocol and stack
+ * documentation is rooted in include/net/wimax.h.
+ */
+
+#ifndef __LINUX__WIMAX_H__
+#define __LINUX__WIMAX_H__
+
+#include <linux/types.h>
+
+enum {
+        /**
+         * Version of the interface (unsigned decimal, MMm, max 25.5)
+         * M - Major: change if removing or modifying an existing call.
+         * m - minor: change when adding a new call
+         */
+        WIMAX_GNL_VERSION = 00,
+        /* Generic NetLink attributes */
+        WIMAX_GNL_ATTR_INVALID = 0x00,
+        WIMAX_GNL_ATTR_MAX = 10,
+};
+
+
+/*
+ * Generic NetLink operations
+ *
+ * Most of these map to an API call; _OP_ stands for operation, _RP_
+ * for reply and _RE_ for report (aka: signal).
+ */
+enum {
+        WIMAX_GNL_OP_MSG_FROM_USER,     /* User to kernel message */
+        WIMAX_GNL_OP_MSG_TO_USER,       /* Kernel to user message */
+        WIMAX_GNL_OP_RFKILL,    /* Run wimax_rfkill() */
+        WIMAX_GNL_OP_RESET,     /* Run wimax_rfkill() */
+        WIMAX_GNL_RE_STATE_CHANGE,      /* Report: status change */
+};
+
+
+/* Message from user / to user */
+enum {
+        WIMAX_GNL_MSG_IFIDX = 1,
+        WIMAX_GNL_MSG_PIPE_NAME,
+        WIMAX_GNL_MSG_DATA,
+};
+
+
+/*
+ * wimax_rfkill()
+ *
+ * The state of the radio (ON/OFF) is mapped to the rfkill subsystem's
+ * switch state (DISABLED/ENABLED).
+ */
+enum wimax_rf_state {
+        WIMAX_RF_OFF = 0,       /* Radio is off, rfkill on/enabled */
+        WIMAX_RF_ON = 1,        /* Radio is on, rfkill off/disabled */
+        WIMAX_RF_QUERY = 2,
+};
+
+/* Attributes */
+enum {
+        WIMAX_GNL_RFKILL_IFIDX = 1,
+        WIMAX_GNL_RFKILL_STATE,
+};
+
+
+/* Attributes for wimax_reset() */
+enum {
+        WIMAX_GNL_RESET_IFIDX = 1,
+};
+
+
+/*
+ * Attributes for the Report State Change
+ *
+ * For now we just have the old and new states; new attributes might
+ * be added later on.
+ */
+enum {
+        WIMAX_GNL_STCH_IFIDX = 1,
+        WIMAX_GNL_STCH_STATE_OLD,
+        WIMAX_GNL_STCH_STATE_NEW,
+};
+
+
+/**
+ * enum wimax_st - The different states of a WiMAX device
+ * @__WIMAX_ST_NULL: The device structure has been allocated and zeroed,
+ *     but still wimax_dev_add() hasn't been called. There is no state.
+ *
+ * @WIMAX_ST_DOWN: The device has been registered with the WiMAX and
+ *     networking stacks, but it is not initialized (normally that is
+ *     done with 'ifconfig DEV up' [or equivalent], which can upload
+ *     firmware and enable communications with the device).
+ *     In this state, the device is powered down and using as less
+ *     power as possible.
+ *     This state is the default after a call to wimax_dev_add(). It
+ *     is ok to have drivers move directly to %WIMAX_ST_UNINITIALIZED
+ *     or %WIMAX_ST_RADIO_OFF in _probe() after the call to
+ *     wimax_dev_add().
+ *     It is recommended that the driver leaves this state when
+ *     calling 'ifconfig DEV up' and enters it back on 'ifconfig DEV
+ *     down'.
+ *
+ * @__WIMAX_ST_QUIESCING: The device is being torn down, so no API
+ *     operations are allowed to proceed except the ones needed to
+ *     complete the device clean up process.
+ *
+ * @WIMAX_ST_UNINITIALIZED: [optional] Communication with the device
+ *     is setup, but the device still requires some configuration
+ *     before being operational.
+ *     Some WiMAX API calls might work.
+ *
+ * @WIMAX_ST_RADIO_OFF: The device is fully up; radio is off (wether
+ *     by hardware or software switches).
+ *     It is recommended to always leave the device in this state
+ *     after initialization.
+ *
+ * @WIMAX_ST_READY: The device is fully up and radio is on.
+ *
+ * @WIMAX_ST_SCANNING: [optional] The device has been instructed to
+ *     scan. In this state, the device cannot be actively connected to
+ *     a network.
+ *
+ * @WIMAX_ST_CONNECTING: The device is connecting to a network. This
+ *     state exists because in some devices, the connect process can
+ *     include a number of negotiations between user space, kernel
+ *     space and the device. User space needs to know what the device
+ *     is doing. If the connect sequence in a device is atomic and
+ *     fast, the device can transition directly to CONNECTED
+ *
+ * @WIMAX_ST_CONNECTED: The device is connected to a network.
+ *
+ * @__WIMAX_ST_INVALID: This is an invalid state used to mark the
+ *     maximum numeric value of states.
+ *
+ * Description:
+ *
+ * Transitions from one state to another one are atomic and can only
+ * be caused in kernel space with wimax_state_change(). To read the
+ * state, use wimax_state_get().
+ *
+ * States starting with __ are internal and shall not be used or
+ * referred to by drivers or userspace. They look ugly, but that's the
+ * point -- if any use is made non-internal to the stack, it is easier
+ * to catch on review.
+ *
+ * All API operations [with well defined exceptions] will take the
+ * device mutex before starting and then check the state. If the state
+ * is %__WIMAX_ST_NULL, %WIMAX_ST_DOWN, %WIMAX_ST_UNINITIALIZED or
+ * %__WIMAX_ST_QUIESCING, it will drop the lock and quit with
+ * -%EINVAL, -%ENOMEDIUM, -%ENOTCONN or -%ESHUTDOWN.
+ *
+ * The order of the definitions is important, so we can do numerical
+ * comparisons (eg: < %WIMAX_ST_RADIO_OFF means the device is not ready
+ * to operate).
+ */
+/*
+ * The allowed state transitions are described in the table below
+ * (states in rows can go to states in columns where there is an X):
+ *
+ *                                  UNINI   RADIO READY SCAN CONNEC CONNEC
+ *             NULL DOWN QUIESCING TIALIZED  OFF        NING  TING   TED
+ * NULL         -    x
+ * DOWN              -      x        x       x
+ * QUIESCING         x      -
+ * UNINITIALIZED            x        -       x
+ * RADIO_OFF                x                -     x
+ * READY                    x                x     -     x     x      x
+ * SCANNING                 x                x     x     -     x      x
+ * CONNECTING               x                x     x     x     -      x
+ * CONNECTED                x                x     x                  -
+ *
+ * This table not available in kernel-doc because the formatting messes it up.
+ */
+ enum wimax_st {
+        __WIMAX_ST_NULL = 0,
+        WIMAX_ST_DOWN,
+        __WIMAX_ST_QUIESCING,
+        WIMAX_ST_UNINITIALIZED,
+        WIMAX_ST_RADIO_OFF,
+        WIMAX_ST_READY,
+        WIMAX_ST_SCANNING,
+        WIMAX_ST_CONNECTING,
+        WIMAX_ST_CONNECTED,
+        __WIMAX_ST_INVALID                      /* Always keep last */
+};
+
+
+#endif /* #ifndef __LINUX__WIMAX_H__ */