5 files changed, 22 insertions, 17 deletions

diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c
index a4c086f069b1..e63b7c40d0ee 100644
--- a/drivers/net/wireless/ath/ath5k/base.c
+++ b/drivers/net/wireless/ath/ath5k/base.c
@@ -1903,17 +1903,6 @@ accept:
                 rxs->noise = sc->ah->ah_noise_floor;
                 rxs->signal = rxs->noise + rs.rs_rssi;
 
-                /* An rssi of 35 indicates you should be able use
-                 * 54 Mbps reliably. A more elaborate scheme can be used
-                 * here but it requires a map of SNR/throughput for each
-                 * possible mode used */
-                rxs->qual = rs.rs_rssi * 100 / 35;
-
-                /* rssi can be more than 35 though, anything above that
-                 * should be considered at 100% */
-                if (rxs->qual > 100)
-                        rxs->qual = 100;
-
                 rxs->antenna = rs.rs_antenna;
                 rxs->rate_idx = ath5k_hw_to_driver_rix(sc, rs.rs_rate);
                 rxs->flag |= ath5k_rx_decrypted(sc, ds, skb, &rs);
@@ -2381,6 +2370,9 @@ ath5k_init(struct ath5k_softc *sc)
          */
         ath5k_stop_locked(sc);
 
+        /* Set PHY calibration interval */
+        ah->ah_cal_intval = ath5k_calinterval;
+
         /*
          * The basic interface to setting the hardware in a good
          * state is ``reset''.  On return the hardware is known to
@@ -2408,10 +2400,6 @@ ath5k_init(struct ath5k_softc *sc)
 
         /* Set ack to be sent at low bit-rates */
         ath5k_hw_set_ack_bitrate_high(ah, false);
-
-        /* Set PHY calibration inteval */
-        ah->ah_cal_intval = ath5k_calinterval;
-
         ret = 0;
 done:
         mmiowb();
diff --git a/drivers/net/wireless/ath/ath9k/mac.h b/drivers/net/wireless/ath/ath9k/mac.h
index 0c87771383f0..e185479e295e 100644
--- a/drivers/net/wireless/ath/ath9k/mac.h
+++ b/drivers/net/wireless/ath/ath9k/mac.h
@@ -77,6 +77,9 @@
 #define ATH9K_TXERR_XTXOP          0x08
 #define ATH9K_TXERR_TIMER_EXPIRED  0x10
 #define ATH9K_TX_ACKED             0x20
+#define ATH9K_TXERR_MASK                                                \
+        (ATH9K_TXERR_XRETRY | ATH9K_TXERR_FILT | ATH9K_TXERR_FIFO |     \
+         ATH9K_TXERR_XTXOP | ATH9K_TXERR_TIMER_EXPIRED)
 
 #define ATH9K_TX_BA                0x01
 #define ATH9K_TX_PWRMGMT           0x02
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c
index 9e68c1a8aef0..996eb90263cc 100644
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
@@ -2514,6 +2514,9 @@ static void ath9k_stop(struct ieee80211_hw *hw)
                 return; /* another wiphy still in use */
         }
 
+        /* Ensure HW is awake when we try to shut it down. */
+        ath9k_ps_wakeup(sc);
+
         if (ah->btcoex_hw.enabled) {
                 ath9k_hw_btcoex_disable(ah);
                 if (ah->btcoex_hw.scheme == ATH_BTCOEX_CFG_3WIRE)
@@ -2534,6 +2537,9 @@ static void ath9k_stop(struct ieee80211_hw *hw)
         /* disable HAL and put h/w to sleep */
         ath9k_hw_disable(ah);
         ath9k_hw_configpcipowersave(ah, 1, 1);
+        ath9k_ps_restore(sc);
+
+        /* Finally, put the chip in FULL SLEEP mode */
         ath9k_setpower(sc, ATH9K_PM_FULL_SLEEP);
 
         sc->sc_flags |= SC_OP_INVALID;
@@ -2647,8 +2653,10 @@ static void ath9k_remove_interface(struct ieee80211_hw *hw,
         if ((sc->sc_ah->opmode == NL80211_IFTYPE_AP) ||
             (sc->sc_ah->opmode == NL80211_IFTYPE_ADHOC) ||
             (sc->sc_ah->opmode == NL80211_IFTYPE_MESH_POINT)) {
+                ath9k_ps_wakeup(sc);
                 ath9k_hw_stoptxdma(sc->sc_ah, sc->beacon.beaconq);
                 ath_beacon_return(sc, avp);
+                ath9k_ps_restore(sc);
         }
 
         sc->sc_flags &= ~SC_OP_BEACONS;
@@ -3097,15 +3105,21 @@ static int ath9k_ampdu_action(struct ieee80211_hw *hw,
         case IEEE80211_AMPDU_RX_STOP:
                 break;
         case IEEE80211_AMPDU_TX_START:
+                ath9k_ps_wakeup(sc);
                 ath_tx_aggr_start(sc, sta, tid, ssn);
                 ieee80211_start_tx_ba_cb_irqsafe(vif, sta->addr, tid);
+                ath9k_ps_restore(sc);
                 break;
         case IEEE80211_AMPDU_TX_STOP:
+                ath9k_ps_wakeup(sc);
                 ath_tx_aggr_stop(sc, sta, tid);
                 ieee80211_stop_tx_ba_cb_irqsafe(vif, sta->addr, tid);
+                ath9k_ps_restore(sc);
                 break;
         case IEEE80211_AMPDU_TX_OPERATIONAL:
+                ath9k_ps_wakeup(sc);
                 ath_tx_aggr_resume(sc, sta, tid);
+                ath9k_ps_restore(sc);
                 break;
         default:
                 ath_print(ath9k_hw_common(sc->sc_ah), ATH_DBG_FATAL,
diff --git a/drivers/net/wireless/ath/ath9k/pci.c b/drivers/net/wireless/ath/ath9k/pci.c
index 5321f735e5a0..f7af5ea54753 100644
--- a/drivers/net/wireless/ath/ath9k/pci.c
+++ b/drivers/net/wireless/ath/ath9k/pci.c
@@ -96,7 +96,7 @@ static void ath_pci_bt_coex_prep(struct ath_common *common)
         pci_write_config_byte(pdev, ATH_PCIE_CAP_LINK_CTRL, aspm);
 }
 
-const static struct ath_bus_ops ath_pci_bus_ops = {
+static const struct ath_bus_ops ath_pci_bus_ops = {
         .read_cachesize = ath_pci_read_cachesize,
         .cleanup = ath_pci_cleanup,
         .eeprom_read = ath_pci_eeprom_read,
diff --git a/drivers/net/wireless/ath/ath9k/xmit.c b/drivers/net/wireless/ath/ath9k/xmit.c
index 1e813bbf474a..fa12b9060b0b 100644
--- a/drivers/net/wireless/ath/ath9k/xmit.c
+++ b/drivers/net/wireless/ath/ath9k/xmit.c
@@ -2072,7 +2072,7 @@ static void ath_tx_processq(struct ath_softc *sc, struct ath_txq *txq)
                                 &txq->axq_q, lastbf->list.prev);
 
                 txq->axq_depth--;
-                txok = !(ds->ds_txstat.ts_status & ATH9K_TXERR_FILT);
+                txok = !(ds->ds_txstat.ts_status & ATH9K_TXERR_MASK);
                 txq->axq_tx_inprogress = false;
                 spin_unlock_bh(&txq->axq_lock);