1 files changed, 3 insertions, 3 deletions

diff --git a/drivers/net/wireless/ath/ath5k/phy.c b/drivers/net/wireless/ath/ath5k/phy.c
index 1a039f2bd732..6f04cc758dcc 100644
--- a/drivers/net/wireless/ath/ath5k/phy.c
+++ b/drivers/net/wireless/ath/ath5k/phy.c
@@ -117,7 +117,7 @@ static unsigned int ath5k_hw_rfb_op(struct ath5k_hw *ah,
 
 /*
  * This code is used to optimize rf gain on different environments
- * (temprature mostly) based on feedback from a power detector.
+ * (temperature mostly) based on feedback from a power detector.
  *
  * It's only used on RF5111 and RF5112, later RF chips seem to have
  * auto adjustment on hw -notice they have a much smaller BANK 7 and
@@ -2675,7 +2675,7 @@ ath5k_setup_channel_powertable(struct ath5k_hw *ah,
                 /* Fill curves in reverse order
                  * from lower power (max gain)
                  * to higher power. Use curve -> idx
-                 * backmaping we did on eeprom init */
+                 * backmapping we did on eeprom init */
                 u8 idx = pdg_curve_to_idx[pdg];
 
                 /* Grab the needed curves by index */
@@ -2777,7 +2777,7 @@ ath5k_setup_channel_powertable(struct ath5k_hw *ah,
         /* Now we have a set of curves for this
          * channel on tmpL (x range is table_max - table_min
          * and y values are tmpL[pdg][]) sorted in the same
-         * order as EEPROM (because we've used the backmaping).
+         * order as EEPROM (because we've used the backmapping).
          * So for RF5112 it's from higher power to lower power
          * and for RF2413 it's from lower power to higher power.
          * For RF5111 we only have one curve. */