4 files changed, 32 insertions, 15 deletions

diff --git a/drivers/i2c/busses/i2c-designware-core.c b/drivers/i2c/busses/i2c-designware-core.c
index dbecf08399f8..5888feef1ac5 100644
--- a/drivers/i2c/busses/i2c-designware-core.c
+++ b/drivers/i2c/busses/i2c-designware-core.c
@@ -98,6 +98,8 @@
 
 #define DW_IC_ERR_TX_ABRT       0x1
 
+#define DW_IC_TAR_10BITADDR_MASTER BIT(12)
+
 /*
  * status codes
  */
@@ -388,22 +390,34 @@ static int i2c_dw_wait_bus_not_busy(struct dw_i2c_dev *dev)
 static void i2c_dw_xfer_init(struct dw_i2c_dev *dev)
 {
         struct i2c_msg *msgs = dev->msgs;
-        u32 ic_con;
+        u32 ic_con, ic_tar = 0;
 
         /* Disable the adapter */
         __i2c_dw_enable(dev, false);
 
-        /* set the slave (target) address */
-        dw_writel(dev, msgs[dev->msg_write_idx].addr, DW_IC_TAR);
-
         /* if the slave address is ten bit address, enable 10BITADDR */
         ic_con = dw_readl(dev, DW_IC_CON);
-        if (msgs[dev->msg_write_idx].flags & I2C_M_TEN)
+        if (msgs[dev->msg_write_idx].flags & I2C_M_TEN) {
                 ic_con |= DW_IC_CON_10BITADDR_MASTER;
-        else
+                /*
+                 * If I2C_DYNAMIC_TAR_UPDATE is set, the 10-bit addressing
+                 * mode has to be enabled via bit 12 of IC_TAR register.
+                 * We set it always as I2C_DYNAMIC_TAR_UPDATE can't be
+                 * detected from registers.
+                 */
+                ic_tar = DW_IC_TAR_10BITADDR_MASTER;
+        } else {
                 ic_con &= ~DW_IC_CON_10BITADDR_MASTER;
+        }
+
         dw_writel(dev, ic_con, DW_IC_CON);
 
+        /*
+         * Set the slave (target) address and enable 10-bit addressing mode
+         * if applicable.
+         */
+        dw_writel(dev, msgs[dev->msg_write_idx].addr | ic_tar, DW_IC_TAR);
+
         /* Enable the adapter */
         __i2c_dw_enable(dev, true);
 
diff --git a/drivers/i2c/busses/i2c-ismt.c b/drivers/i2c/busses/i2c-ismt.c
index 8ed79a086f85..1672effbcebb 100644
--- a/drivers/i2c/busses/i2c-ismt.c
+++ b/drivers/i2c/busses/i2c-ismt.c
@@ -393,6 +393,9 @@ static int ismt_access(struct i2c_adapter *adap, u16 addr,
 
         desc = &priv->hw[priv->head];
 
+        /* Initialize the DMA buffer */
+        memset(priv->dma_buffer, 0, sizeof(priv->dma_buffer));
+
         /* Initialize the descriptor */
         memset(desc, 0, sizeof(struct ismt_desc));
         desc->tgtaddr_rw = ISMT_DESC_ADDR_RW(addr, read_write);
diff --git a/drivers/i2c/busses/i2c-mv64xxx.c b/drivers/i2c/busses/i2c-mv64xxx.c
index 7f3a47443494..d3e9cc3153a9 100644
--- a/drivers/i2c/busses/i2c-mv64xxx.c
+++ b/drivers/i2c/busses/i2c-mv64xxx.c
@@ -234,9 +234,9 @@ static int mv64xxx_i2c_offload_msg(struct mv64xxx_i2c_data *drv_data)
                 ctrl_reg |= MV64XXX_I2C_BRIDGE_CONTROL_WR |
                     (msg->len - 1) << MV64XXX_I2C_BRIDGE_CONTROL_TX_SIZE_SHIFT;
 
-                writel_relaxed(data_reg_lo,
+                writel(data_reg_lo,
                         drv_data->reg_base + MV64XXX_I2C_REG_TX_DATA_LO);
-                writel_relaxed(data_reg_hi,
+                writel(data_reg_hi,
                         drv_data->reg_base + MV64XXX_I2C_REG_TX_DATA_HI);
 
         } else {
@@ -697,6 +697,7 @@ static const struct of_device_id mv64xxx_i2c_of_match_table[] = {
 MODULE_DEVICE_TABLE(of, mv64xxx_i2c_of_match_table);
 
 #ifdef CONFIG_OF
+#ifdef CONFIG_HAVE_CLK
 static int
 mv64xxx_calc_freq(const int tclk, const int n, const int m)
 {
@@ -726,16 +727,12 @@ mv64xxx_find_baud_factors(const u32 req_freq, const u32 tclk, u32 *best_n,
                 return false;
         return true;
 }
+#endif /* CONFIG_HAVE_CLK */
 
 static int
 mv64xxx_of_config(struct mv64xxx_i2c_data *drv_data,
                   struct device *dev)
 {
-        const struct of_device_id *device;
-        struct device_node *np = dev->of_node;
-        u32 bus_freq, tclk;
-        int rc = 0;
-
         /* CLK is mandatory when using DT to describe the i2c bus. We
          * need to know tclk in order to calculate bus clock
          * factors.
@@ -744,6 +741,11 @@ mv64xxx_of_config(struct mv64xxx_i2c_data *drv_data,
         /* Have OF but no CLK */
         return -ENODEV;
 #else
+        const struct of_device_id *device;
+        struct device_node *np = dev->of_node;
+        u32 bus_freq, tclk;
+        int rc = 0;
+
         if (IS_ERR(drv_data->clk)) {
                 rc = -ENODEV;
                 goto out;
diff --git a/drivers/i2c/busses/i2c-s3c2410.c b/drivers/i2c/busses/i2c-s3c2410.c
index 3535f3c0f7b4..3747b9bf67d6 100644
--- a/drivers/i2c/busses/i2c-s3c2410.c
+++ b/drivers/i2c/busses/i2c-s3c2410.c
@@ -1178,8 +1178,6 @@ static int s3c24xx_i2c_remove(struct platform_device *pdev)
 
         i2c_del_adapter(&i2c->adap);
 
-        clk_disable_unprepare(i2c->clk);
-
         if (pdev->dev.of_node && IS_ERR(i2c->pctrl))
                 s3c24xx_i2c_dt_gpio_free(i2c);