1 files changed, 16 insertions, 26 deletions

diff --git a/arch/arm/mach-at91/include/mach/board.h b/arch/arm/mach-at91/include/mach/board.h
index eac92e995bb5..d0b377b21bd7 100644
--- a/arch/arm/mach-at91/include/mach/board.h
+++ b/arch/arm/mach-at91/include/mach/board.h
@@ -40,13 +40,14 @@
 #include <linux/atmel-mci.h>
 #include <sound/atmel-ac97c.h>
 #include <linux/serial.h>
+#include <linux/platform_data/macb.h>
 
  /* USB Device */
 struct at91_udc_data {
-        u8      vbus_pin;               /* high == host powering us */
+        int     vbus_pin;               /* high == host powering us */
         u8      vbus_active_low;        /* vbus polarity */
         u8      vbus_polled;            /* Use polling, not interrupt */
-        u8      pullup_pin;             /* active == D+ pulled up */
+        int     pullup_pin;             /* active == D+ pulled up */
         u8      pullup_active_low;      /* true == pullup_pin is active low */
 };
 extern void __init at91_add_device_udc(struct at91_udc_data *data);
@@ -56,10 +57,10 @@ extern void __init at91_add_device_usba(struct usba_platform_data *data);
 
  /* Compact Flash */
 struct at91_cf_data {
-        u8      irq_pin;                /* I/O IRQ */
-        u8      det_pin;                /* Card detect */
-        u8      vcc_pin;                /* power switching */
-        u8      rst_pin;                /* card reset */
+        int     irq_pin;                /* I/O IRQ */
+        int     det_pin;                /* Card detect */
+        int     vcc_pin;                /* power switching */
+        int     rst_pin;                /* card reset */
         u8      chipselect;             /* EBI Chip Select number */
         u8      flags;
 #define AT91_CF_TRUE_IDE        0x01
@@ -70,37 +71,26 @@ extern void __init at91_add_device_cf(struct at91_cf_data *data);
  /* MMC / SD */
   /* at91_mci platform config */
 struct at91_mmc_data {
-        u8              det_pin;        /* card detect IRQ */
+        int             det_pin;        /* card detect IRQ */
         unsigned        slot_b:1;       /* uses Slot B */
         unsigned        wire4:1;        /* (SD) supports DAT0..DAT3 */
-        u8              wp_pin;         /* (SD) writeprotect detect */
-        u8              vcc_pin;        /* power switching (high == on) */
+        int             wp_pin;         /* (SD) writeprotect detect */
+        int             vcc_pin;        /* power switching (high == on) */
 };
 extern void __init at91_add_device_mmc(short mmc_id, struct at91_mmc_data *data);
 
   /* atmel-mci platform config */
 extern void __init at91_add_device_mci(short mmc_id, struct mci_platform_data *data);
 
- /* Ethernet (EMAC & MACB) */
-struct at91_eth_data {
-        u32             phy_mask;
-        u8              phy_irq_pin;    /* PHY IRQ */
-        u8              is_rmii;        /* using RMII interface? */
-};
-extern void __init at91_add_device_eth(struct at91_eth_data *data);
-
-#if defined(CONFIG_ARCH_AT91SAM9260) || defined(CONFIG_ARCH_AT91SAM9263) || defined(CONFIG_ARCH_AT91SAM9G20) || defined(CONFIG_ARCH_AT91CAP9) \
-        || defined(CONFIG_ARCH_AT91SAM9G45)
-#define eth_platform_data       at91_eth_data
-#endif
+extern void __init at91_add_device_eth(struct macb_platform_data *data);
 
  /* USB Host */
 struct at91_usbh_data {
         u8              ports;          /* number of ports on root hub */
-        u8              vbus_pin[2];    /* port power-control pin */
+        int             vbus_pin[2];    /* port power-control pin */
         u8              vbus_pin_inverted;
         u8              overcurrent_supported;
-        u8              overcurrent_pin[2];
+        int             overcurrent_pin[2];
         u8              overcurrent_status[2];
         u8              overcurrent_changed[2];
 };
@@ -110,9 +100,9 @@ extern void __init at91_add_device_usbh_ehci(struct at91_usbh_data *data);
 
  /* NAND / SmartMedia */
 struct atmel_nand_data {
-        u8              enable_pin;     /* chip enable */
-        u8              det_pin;        /* card detect */
-        u8              rdy_pin;        /* ready/busy */
+        int             enable_pin;     /* chip enable */
+        int             det_pin;        /* card detect */
+        int             rdy_pin;        /* ready/busy */
         u8              rdy_pin_active_low;     /* rdy_pin value is inverted */
         u8              ale;            /* address line number connected to ALE */
         u8              cle;            /* address line number connected to CLE */