2 files changed, 7 insertions, 7 deletions

diff --git a/Documentation/cgroups/cpusets.txt b/Documentation/cgroups/cpusets.txt
index 3c94ff3f9693..f2235a162529 100644
--- a/Documentation/cgroups/cpusets.txt
+++ b/Documentation/cgroups/cpusets.txt
@@ -445,7 +445,7 @@ across partially overlapping sets of CPUs would risk unstable dynamics
 that would be beyond our understanding.  So if each of two partially
 overlapping cpusets enables the flag 'cpuset.sched_load_balance', then we
 form a single sched domain that is a superset of both.  We won't move
-a task to a CPU outside it cpuset, but the scheduler load balancing
+a task to a CPU outside its cpuset, but the scheduler load balancing
 code might waste some compute cycles considering that possibility.
 
 This mismatch is why there is not a simple one-to-one relation
@@ -552,8 +552,8 @@ otherwise initial value -1 that indicates the cpuset has no request.
    1  : search siblings (hyperthreads in a core).
    2  : search cores in a package.
    3  : search cpus in a node [= system wide on non-NUMA system]
- ( 4  : search nodes in a chunk of node [on NUMA system] )
- ( 5  : search system wide [on NUMA system] )
+   4  : search nodes in a chunk of node [on NUMA system]
+   5  : search system wide [on NUMA system]
 
 The system default is architecture dependent.  The system default
 can be changed using the relax_domain_level= boot parameter.
diff --git a/Documentation/cgroups/memory.txt b/Documentation/cgroups/memory.txt
index 46b2b5080317..a22df3ad35ff 100644
--- a/Documentation/cgroups/memory.txt
+++ b/Documentation/cgroups/memory.txt
@@ -326,7 +326,7 @@ per cgroup, instead of globally.
 
 * tcp memory pressure: sockets memory pressure for the tcp protocol.
 
-2.7.3 Common use cases
+2.7.2 Common use cases
 
 Because the "kmem" counter is fed to the main user counter, kernel memory can
 never be limited completely independently of user memory. Say "U" is the user
@@ -354,19 +354,19 @@ set:
 
 3. User Interface
 
-0. Configuration
+3.0. Configuration
 
 a. Enable CONFIG_CGROUPS
 b. Enable CONFIG_MEMCG
 c. Enable CONFIG_MEMCG_SWAP (to use swap extension)
 d. Enable CONFIG_MEMCG_KMEM (to use kmem extension)
 
-1. Prepare the cgroups (see cgroups.txt, Why are cgroups needed?)
+3.1. Prepare the cgroups (see cgroups.txt, Why are cgroups needed?)
 # mount -t tmpfs none /sys/fs/cgroup
 # mkdir /sys/fs/cgroup/memory
 # mount -t cgroup none /sys/fs/cgroup/memory -o memory
 
-2. Make the new group and move bash into it
+3.2. Make the new group and move bash into it
 # mkdir /sys/fs/cgroup/memory/0
 # echo $$ > /sys/fs/cgroup/memory/0/tasks