3 files changed, 35 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/serial/of-serial.txt b/Documentation/devicetree/bindings/serial/8250.txt
index 91d5ab0e60fc..91d5ab0e60fc 100644
--- a/Documentation/devicetree/bindings/serial/of-serial.txt
+++ b/Documentation/devicetree/bindings/serial/8250.txt
diff --git a/Documentation/devicetree/bindings/serial/axis,etraxfs-uart.txt b/Documentation/devicetree/bindings/serial/axis,etraxfs-uart.txt
new file mode 100644
index 000000000000..ebcbb62c0a76
--- /dev/null
+++ b/Documentation/devicetree/bindings/serial/axis,etraxfs-uart.txt
@@ -0,0 +1,19 @@
+ETRAX FS UART
+
+Required properties:
+- compatible : "axis,etraxfs-uart"
+- reg: offset and length of the register set for the device.
+- interrupts: device interrupt
+
+Optional properties:
+- {dtr,dsr,ri,cd}-gpios: specify a GPIO for DTR/DSR/RI/CD
+  line respectively.
+
+Example:
+
+serial@b00260000 {
+        compatible = "axis,etraxfs-uart";
+        reg = <0xb0026000 0x1000>;
+        interrupts = <68>;
+        status = "disabled";
+};
diff --git a/Documentation/devicetree/bindings/serial/snps-dw-apb-uart.txt b/Documentation/devicetree/bindings/serial/snps-dw-apb-uart.txt
index 7f76214f728a..289c40ed7470 100644
--- a/Documentation/devicetree/bindings/serial/snps-dw-apb-uart.txt
+++ b/Documentation/devicetree/bindings/serial/snps-dw-apb-uart.txt
@@ -21,6 +21,18 @@ Optional properties:
 - reg-io-width : the size (in bytes) of the IO accesses that should be
   performed on the device.  If this property is not present then single byte
   accesses are used.
+- dcd-override : Override the DCD modem status signal. This signal will always
+  be reported as active instead of being obtained from the modem status
+  register. Define this if your serial port does not use this pin.
+- dsr-override : Override the DTS modem status signal. This signal will always
+  be reported as active instead of being obtained from the modem status
+  register. Define this if your serial port does not use this pin.
+- cts-override : Override the CTS modem status signal. This signal will always
+  be reported as active instead of being obtained from the modem status
+  register. Define this if your serial port does not use this pin.
+- ri-override : Override the RI modem status signal. This signal will always be
+  reported as inactive instead of being obtained from the modem status register.
+  Define this if your serial port does not use this pin.
 
 Example:
 
@@ -31,6 +43,10 @@ Example:
                 interrupts = <10>;
                 reg-shift = <2>;
                 reg-io-width = <4>;
+                dcd-override;
+                dsr-override;
+                cts-override;
+                ri-override;
         };
 
 Example with one clock: