aboutsummaryrefslogtreecommitdiffstats
path: root/Documentation/cpu-freq/boost.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/cpu-freq/boost.txt')
-rw-r--r--Documentation/cpu-freq/boost.txt93
1 files changed, 93 insertions, 0 deletions
diff --git a/Documentation/cpu-freq/boost.txt b/Documentation/cpu-freq/boost.txt
new file mode 100644
index 000000000000..9b4edfcf486f
--- /dev/null
+++ b/Documentation/cpu-freq/boost.txt
@@ -0,0 +1,93 @@
1Processor boosting control
2
3 - information for users -
4
5Quick guide for the impatient:
6--------------------
7/sys/devices/system/cpu/cpufreq/boost
8controls the boost setting for the whole system. You can read and write
9that file with either "0" (boosting disabled) or "1" (boosting allowed).
10Reading or writing 1 does not mean that the system is boosting at this
11very moment, but only that the CPU _may_ raise the frequency at it's
12discretion.
13--------------------
14
15Introduction
16-------------
17Some CPUs support a functionality to raise the operating frequency of
18some cores in a multi-core package if certain conditions apply, mostly
19if the whole chip is not fully utilized and below it's intended thermal
20budget. This is done without operating system control by a combination
21of hardware and firmware.
22On Intel CPUs this is called "Turbo Boost", AMD calls it "Turbo-Core",
23in technical documentation "Core performance boost". In Linux we use
24the term "boost" for convenience.
25
26Rationale for disable switch
27----------------------------
28
29Though the idea is to just give better performance without any user
30intervention, sometimes the need arises to disable this functionality.
31Most systems offer a switch in the (BIOS) firmware to disable the
32functionality at all, but a more fine-grained and dynamic control would
33be desirable:
341. While running benchmarks, reproducible results are important. Since
35 the boosting functionality depends on the load of the whole package,
36 single thread performance can vary. By explicitly disabling the boost
37 functionality at least for the benchmark's run-time the system will run
38 at a fixed frequency and results are reproducible again.
392. To examine the impact of the boosting functionality it is helpful
40 to do tests with and without boosting.
413. Boosting means overclocking the processor, though under controlled
42 conditions. By raising the frequency and the voltage the processor
43 will consume more power than without the boosting, which may be
44 undesirable for instance for mobile users. Disabling boosting may
45 save power here, though this depends on the workload.
46
47
48User controlled switch
49----------------------
50
51To allow the user to toggle the boosting functionality, the acpi-cpufreq
52driver exports a sysfs knob to disable it. There is a file:
53/sys/devices/system/cpu/cpufreq/boost
54which can either read "0" (boosting disabled) or "1" (boosting enabled).
55Reading the file is always supported, even if the processor does not
56support boosting. In this case the file will be read-only and always
57reads as "0". Explicitly changing the permissions and writing to that
58file anyway will return EINVAL.
59
60On supported CPUs one can write either a "0" or a "1" into this file.
61This will either disable the boost functionality on all cores in the
62whole system (0) or will allow the hardware to boost at will (1).
63
64Writing a "1" does not explicitly boost the system, but just allows the
65CPU (and the firmware) to boost at their discretion. Some implementations
66take external factors like the chip's temperature into account, so
67boosting once does not necessarily mean that it will occur every time
68even using the exact same software setup.
69
70
71AMD legacy cpb switch
72---------------------
73The AMD powernow-k8 driver used to support a very similar switch to
74disable or enable the "Core Performance Boost" feature of some AMD CPUs.
75This switch was instantiated in each CPU's cpufreq directory
76(/sys/devices/system/cpu[0-9]*/cpufreq) and was called "cpb".
77Though the per CPU existence hints at a more fine grained control, the
78actual implementation only supported a system-global switch semantics,
79which was simply reflected into each CPU's file. Writing a 0 or 1 into it
80would pull the other CPUs to the same state.
81For compatibility reasons this file and its behavior is still supported
82on AMD CPUs, though it is now protected by a config switch
83(X86_ACPI_CPUFREQ_CPB). On Intel CPUs this file will never be created,
84even with the config option set.
85This functionality is considered legacy and will be removed in some future
86kernel version.
87
88More fine grained boosting control
89----------------------------------
90
91Technically it is possible to switch the boosting functionality at least
92on a per package basis, for some CPUs even per core. Currently the driver
93does not support it, but this may be implemented in the future.