xHCI: prolong host controller halt time limit

xHCI 1.0 spec specifies the xHC shall halt within 16ms after software clears
Run/Stop bit. In xHCI 0.96 spec the time limit is 16 microframes (2ms), it's
too short and often cause dmesg shows "Host controller not halted, aborting
reset." message when rmmod xhci-hcd.

Modify the time limit to comply with xHCI 1.0 specification and prevents the
warning message showing when remove xhci-hcd.

Signed-off-by: Andiry Xu <andiry.xu@amd.com>
Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>

1 files changed, 2 insertions, 2 deletions

diff --git a/drivers/usb/host/xhci-ext-caps.h b/drivers/usb/host/xhci-ext-caps.h
index 78c4edac1db1..ce5c9e51748e 100644
--- a/drivers/usb/host/xhci-ext-caps.h
+++ b/drivers/usb/host/xhci-ext-caps.h
@@ -19,8 +19,8 @@
  * along with this program; if not, write to the Free Software Foundation,
  * Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
  */
-/* Up to 16 microframes to halt an HC - one microframe is 125 microsectonds */
-#define XHCI_MAX_HALT_USEC      (16*125)
+/* Up to 16 ms to halt an HC */
+#define XHCI_MAX_HALT_USEC      (16*1000)
 /* HC not running - set to 1 when run/stop bit is cleared. */
 #define XHCI_STS_HALT           (1<<0)