ath9k: Enable manual peak detect calibration

On some AR955x/QCA953x boards, noise floor calibration
gets stuck and the cause is a hardware/BB issue. To fix
this, peak detect calibration in the HW is disabled
and is done in the driver instead. There a few differences
with the calibration routine for older chips like
AR9331.

Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

1 files changed, 8 insertions, 2 deletions

diff --git a/drivers/net/wireless/ath/ath9k/ar9003_calib.c b/drivers/net/wireless/ath/ath9k/ar9003_calib.c
index 91130c0e31d3..174442beb952 100644
--- a/drivers/net/wireless/ath/ath9k/ar9003_calib.c
+++ b/drivers/net/wireless/ath/ath9k/ar9003_calib.c
@@ -1640,8 +1640,14 @@ static bool ar9003_hw_init_cal_soc(struct ath_hw *ah,
 
 skip_tx_iqcal:
         if (run_agc_cal || !(ah->ah_flags & AH_FASTCC)) {
-                if (AR_SREV_9330_11(ah))
-                        ar9003_hw_manual_peak_cal(ah, 0, IS_CHAN_2GHZ(chan));
+                if (AR_SREV_9330_11(ah) || AR_SREV_9531(ah) || AR_SREV_9550(ah)) {
+                        for (i = 0; i < AR9300_MAX_CHAINS; i++) {
+                                if (!(ah->rxchainmask & (1 << i)))
+                                        continue;
+                                ar9003_hw_manual_peak_cal(ah, i,
+                                                          IS_CHAN_2GHZ(chan));
+                        }
+                }
 
                 /*
                  * For non-AR9550 chips, we just trigger AGC calibration