wl12xx: AP-mode - configure HT rate support to the FW

Unconditionally configure HT rate support to the FW on all ACs
when starting the AP.

When 11n support is disabled by usermode (hostapd), each STA joining
the AP will appear as a non-HT STA. This will stop us from accidentally
transmitting using MCS rates.

Signed-off-by: Arik Nemtsov <arik@wizery.com>
Signed-off-by: Eliad Peller <eliad@wizery.com>
Signed-off-by: Luciano Coelho <coelho@ti.com>

1 files changed, 3 insertions, 0 deletions

diff --git a/drivers/net/wireless/wl12xx/init.c b/drivers/net/wireless/wl12xx/init.c
index a374c2112be3..b13bebea95e0 100644
--- a/drivers/net/wireless/wl12xx/init.c
+++ b/drivers/net/wireless/wl12xx/init.c
@@ -515,6 +515,9 @@ int wl1271_init_ap_rates(struct wl1271 *wl)
         else
                 supported_rates = CONF_TX_AP_ENABLED_RATES;
 
+        /* unconditionally enable HT rates */
+        supported_rates |= CONF_TX_MCS_RATES;
+
         /* configure unicast TX rate classes */
         for (i = 0; i < wl->conf.tx.ac_conf_count; i++) {
                 rc.enabled_rates = supported_rates;