iwlwifi: extract iwl-csr.h

This patch extract CSR Register definition into separate
header files as most of the definition are commons to both
3945 and 4965.

Definitions specific for 3945 and 4965 are properly prefixed

Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Reinette Chatre <reinette.chatre@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

1 files changed, 0 insertions, 131 deletions

diff --git a/drivers/net/wireless/iwlwifi/iwl-4965-hw.h b/drivers/net/wireless/iwlwifi/iwl-4965-hw.h
index cc726215ab93..7e8cc9928b55 100644
--- a/drivers/net/wireless/iwlwifi/iwl-4965-hw.h
+++ b/drivers/net/wireless/iwlwifi/iwl-4965-hw.h
@@ -410,137 +410,6 @@ struct iwl4965_eeprom {
 #define PCI_REG_WUM8       0x0E8
 #define PCI_CFG_PMC_PME_FROM_D3COLD_SUPPORT         (0x80000000)
 
-/*=== CSR (control and status registers) ===*/
-#define CSR_BASE    (0x000)
-
-#define CSR_HW_IF_CONFIG_REG    (CSR_BASE+0x000) /* hardware interface config */
-#define CSR_INT_COALESCING      (CSR_BASE+0x004) /* accum ints, 32-usec units */
-#define CSR_INT                 (CSR_BASE+0x008) /* host interrupt status/ack */
-#define CSR_INT_MASK            (CSR_BASE+0x00c) /* host interrupt enable */
-#define CSR_FH_INT_STATUS       (CSR_BASE+0x010) /* busmaster int status/ack*/
-#define CSR_GPIO_IN             (CSR_BASE+0x018) /* read external chip pins */
-#define CSR_RESET               (CSR_BASE+0x020) /* busmaster enable, NMI, etc*/
-#define CSR_GP_CNTRL            (CSR_BASE+0x024)
-
-/*
- * Hardware revision info
- * Bit fields:
- * 31-8:  Reserved
- *  7-4:  Type of device:  0x0 = 4965, 0xd = 3945
- *  3-2:  Revision step:  0 = A, 1 = B, 2 = C, 3 = D
- *  1-0:  "Dash" value, as in A-1, etc.
- *
- * NOTE:  Revision step affects calculation of CCK txpower for 4965.
- */
-#define CSR_HW_REV              (CSR_BASE+0x028)
-
-/* EEPROM reads */
-#define CSR_EEPROM_REG          (CSR_BASE+0x02c)
-#define CSR_EEPROM_GP           (CSR_BASE+0x030)
-#define CSR_GP_UCODE            (CSR_BASE+0x044)
-#define CSR_UCODE_DRV_GP1       (CSR_BASE+0x054)
-#define CSR_UCODE_DRV_GP1_SET   (CSR_BASE+0x058)
-#define CSR_UCODE_DRV_GP1_CLR   (CSR_BASE+0x05c)
-#define CSR_UCODE_DRV_GP2       (CSR_BASE+0x060)
-#define CSR_GIO_CHICKEN_BITS    (CSR_BASE+0x100)
-
-/*
- * Indicates hardware rev, to determine CCK backoff for txpower calculation.
- * Bit fields:
- *  3-2:  0 = A, 1 = B, 2 = C, 3 = D step
- */
-#define CSR_HW_REV_WA_REG       (CSR_BASE+0x22C)
-
-/* Hardware interface configuration bits */
-#define CSR_HW_IF_CONFIG_REG_BIT_KEDRON_R       (0x00000010)
-#define CSR_HW_IF_CONFIG_REG_MSK_BOARD_VER      (0x00000C00)
-#define CSR_HW_IF_CONFIG_REG_BIT_MAC_SI         (0x00000100)
-#define CSR_HW_IF_CONFIG_REG_BIT_RADIO_SI       (0x00000200)
-#define CSR_HW_IF_CONFIG_REG_BIT_EEPROM_OWN_SEM (0x00200000)
-
-/* interrupt flags in INTA, set by uCode or hardware (e.g. dma),
- * acknowledged (reset) by host writing "1" to flagged bits. */
-#define CSR_INT_BIT_FH_RX        (1 << 31) /* Rx DMA, cmd responses, FH_INT[17:16] */
-#define CSR_INT_BIT_HW_ERR       (1 << 29) /* DMA hardware error FH_INT[31] */
-#define CSR_INT_BIT_DNLD         (1 << 28) /* uCode Download */
-#define CSR_INT_BIT_FH_TX        (1 << 27) /* Tx DMA FH_INT[1:0] */
-#define CSR_INT_BIT_SCD          (1 << 26) /* TXQ pointer advanced */
-#define CSR_INT_BIT_SW_ERR       (1 << 25) /* uCode error */
-#define CSR_INT_BIT_RF_KILL      (1 << 7)  /* HW RFKILL switch GP_CNTRL[27] toggled */
-#define CSR_INT_BIT_CT_KILL      (1 << 6)  /* Critical temp (chip too hot) rfkill */
-#define CSR_INT_BIT_SW_RX        (1 << 3)  /* Rx, command responses, 3945 */
-#define CSR_INT_BIT_WAKEUP       (1 << 1)  /* NIC controller waking up (pwr mgmt) */
-#define CSR_INT_BIT_ALIVE        (1 << 0)  /* uCode interrupts once it initializes */
-
-#define CSR_INI_SET_MASK        (CSR_INT_BIT_FH_RX   | \
-                                 CSR_INT_BIT_HW_ERR  | \
-                                 CSR_INT_BIT_FH_TX   | \
-                                 CSR_INT_BIT_SW_ERR  | \
-                                 CSR_INT_BIT_RF_KILL | \
-                                 CSR_INT_BIT_SW_RX   | \
-                                 CSR_INT_BIT_WAKEUP  | \
-                                 CSR_INT_BIT_ALIVE)
-
-/* interrupt flags in FH (flow handler) (PCI busmaster DMA) */
-#define CSR_FH_INT_BIT_ERR       (1 << 31) /* Error */
-#define CSR_FH_INT_BIT_HI_PRIOR  (1 << 30) /* High priority Rx, bypass coalescing */
-#define CSR_FH_INT_BIT_RX_CHNL1  (1 << 17) /* Rx channel 1 */
-#define CSR_FH_INT_BIT_RX_CHNL0  (1 << 16) /* Rx channel 0 */
-#define CSR_FH_INT_BIT_TX_CHNL1  (1 << 1)  /* Tx channel 1 */
-#define CSR_FH_INT_BIT_TX_CHNL0  (1 << 0)  /* Tx channel 0 */
-
-#define CSR_FH_INT_RX_MASK      (CSR_FH_INT_BIT_HI_PRIOR | \
-                                 CSR_FH_INT_BIT_RX_CHNL1 | \
-                                 CSR_FH_INT_BIT_RX_CHNL0)
-
-#define CSR_FH_INT_TX_MASK      (CSR_FH_INT_BIT_TX_CHNL1 | \
-                                 CSR_FH_INT_BIT_TX_CHNL0)
-
-
-/* RESET */
-#define CSR_RESET_REG_FLAG_NEVO_RESET                (0x00000001)
-#define CSR_RESET_REG_FLAG_FORCE_NMI                 (0x00000002)
-#define CSR_RESET_REG_FLAG_SW_RESET                  (0x00000080)
-#define CSR_RESET_REG_FLAG_MASTER_DISABLED           (0x00000100)
-#define CSR_RESET_REG_FLAG_STOP_MASTER               (0x00000200)
-
-/* GP (general purpose) CONTROL */
-#define CSR_GP_CNTRL_REG_FLAG_MAC_CLOCK_READY        (0x00000001)
-#define CSR_GP_CNTRL_REG_FLAG_INIT_DONE              (0x00000004)
-#define CSR_GP_CNTRL_REG_FLAG_MAC_ACCESS_REQ         (0x00000008)
-#define CSR_GP_CNTRL_REG_FLAG_GOING_TO_SLEEP         (0x00000010)
-
-#define CSR_GP_CNTRL_REG_VAL_MAC_ACCESS_EN           (0x00000001)
-
-#define CSR_GP_CNTRL_REG_MSK_POWER_SAVE_TYPE         (0x07000000)
-#define CSR_GP_CNTRL_REG_FLAG_MAC_POWER_SAVE         (0x04000000)
-#define CSR_GP_CNTRL_REG_FLAG_HW_RF_KILL_SW          (0x08000000)
-
-
-/* EEPROM REG */
-#define CSR_EEPROM_REG_READ_VALID_MSK   (0x00000001)
-#define CSR_EEPROM_REG_BIT_CMD          (0x00000002)
-
-/* EEPROM GP */
-#define CSR_EEPROM_GP_VALID_MSK         (0x00000006)
-#define CSR_EEPROM_GP_BAD_SIGNATURE     (0x00000000)
-#define CSR_EEPROM_GP_IF_OWNER_MSK      (0x00000180)
-
-/* UCODE DRV GP */
-#define CSR_UCODE_DRV_GP1_BIT_MAC_SLEEP             (0x00000001)
-#define CSR_UCODE_SW_BIT_RFKILL                     (0x00000002)
-#define CSR_UCODE_DRV_GP1_BIT_CMD_BLOCKED           (0x00000004)
-#define CSR_UCODE_DRV_GP1_REG_BIT_CT_KILL_EXIT      (0x00000008)
-
-/* GPIO */
-#define CSR_GPIO_IN_BIT_AUX_POWER                   (0x00000200)
-#define CSR_GPIO_IN_VAL_VAUX_PWR_SRC                (0x00000000)
-#define CSR_GPIO_IN_VAL_VMAIN_PWR_SRC           CSR_GPIO_IN_BIT_AUX_POWER
-
-/* GI Chicken Bits */
-#define CSR_GIO_CHICKEN_BITS_REG_BIT_L1A_NO_L0S_RX  (0x00800000)
-#define CSR_GIO_CHICKEN_BITS_REG_BIT_DIS_L0S_EXIT_TIMER  (0x20000000)
-
 /*=== HBUS (Host-side Bus) ===*/
 #define HBUS_BASE       (0x400)