Merge branch 'fix/hda' into topic/hda

Conflicts:
	sound/pci/hda/patch_realtek.c

1 files changed, 3 insertions, 15 deletions

diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c
index a4c086f069b1..e63b7c40d0ee 100644
--- a/drivers/net/wireless/ath/ath5k/base.c
+++ b/drivers/net/wireless/ath/ath5k/base.c
@@ -1903,17 +1903,6 @@ accept:
                 rxs->noise = sc->ah->ah_noise_floor;
                 rxs->signal = rxs->noise + rs.rs_rssi;
 
-                /* An rssi of 35 indicates you should be able use
-                 * 54 Mbps reliably. A more elaborate scheme can be used
-                 * here but it requires a map of SNR/throughput for each
-                 * possible mode used */
-                rxs->qual = rs.rs_rssi * 100 / 35;
-
-                /* rssi can be more than 35 though, anything above that
-                 * should be considered at 100% */
-                if (rxs->qual > 100)
-                        rxs->qual = 100;
-
                 rxs->antenna = rs.rs_antenna;
                 rxs->rate_idx = ath5k_hw_to_driver_rix(sc, rs.rs_rate);
                 rxs->flag |= ath5k_rx_decrypted(sc, ds, skb, &rs);
@@ -2381,6 +2370,9 @@ ath5k_init(struct ath5k_softc *sc)
          */
         ath5k_stop_locked(sc);
 
+        /* Set PHY calibration interval */
+        ah->ah_cal_intval = ath5k_calinterval;
+
         /*
          * The basic interface to setting the hardware in a good
          * state is ``reset''.  On return the hardware is known to
@@ -2408,10 +2400,6 @@ ath5k_init(struct ath5k_softc *sc)
 
         /* Set ack to be sent at low bit-rates */
         ath5k_hw_set_ack_bitrate_high(ah, false);
-
-        /* Set PHY calibration inteval */
-        ah->ah_cal_intval = ath5k_calinterval;
-
         ret = 0;
 done:
         mmiowb();