mmc: do not switch to 1-bit mode if not required

6b5eda36 followed SDIO spec part E1 section 8, which states that
in case SDIO interrupts are being used to wake up a suspended host,
then it is required to switch to 1-bit mode before stopping the clock.

Before switching to 1-bit mode (or back to 4-bit mode on resume),
make sure that SDIO interrupts are really being used to wake the host.

This is helpful for devices which have an external irq line (e.g.
wl1271), and do not use SDIO interrupts to wake up the host.

In this case, switching to 1-bit mode (and back to 4-bit mode on resume)
is not necessary.

Reported-by: Eliad Peller <eliad@wizery.com>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

1 files changed, 2 insertions, 2 deletions

diff --git a/drivers/mmc/core/sdio.c b/drivers/mmc/core/sdio.c
index 0f7d4362d213..4221670bf82e 100644
--- a/drivers/mmc/core/sdio.c
+++ b/drivers/mmc/core/sdio.c
@@ -625,7 +625,7 @@ static int mmc_sdio_suspend(struct mmc_host *host)
                 }
         }
 
-        if (!err && mmc_card_keep_power(host)) {
+        if (!err && mmc_card_keep_power(host) && mmc_card_wake_sdio_irq(host)) {
                 mmc_claim_host(host);
                 sdio_disable_wide(host->card);
                 mmc_release_host(host);
@@ -648,7 +648,7 @@ static int mmc_sdio_resume(struct mmc_host *host)
         if (mmc_card_is_removable(host) || !mmc_card_keep_power(host))
                 err = mmc_sdio_init_card(host, host->ocr, host->card,
                                         mmc_card_keep_power(host));
-        else if (mmc_card_keep_power(host)) {
+        else if (mmc_card_keep_power(host) && mmc_card_wake_sdio_irq(host)) {
                 /* We may have switched to 1-bit mode during suspend */
                 err = sdio_enable_4bit_bus(host->card);
                 if (err > 0) {