mach-ux500: set proper I2C platform data from MOP500s

This specifies the new per-platform timeout per I2C bus and
switches the I2C buses to fast mode, and increase the FIFO
depth to 8 for reads and writes.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>

1 files changed, 8 insertions, 6 deletions

diff --git a/arch/arm/mach-ux500/board-mop500.c b/arch/arm/mach-ux500/board-mop500.c
index 6e1907fa94f0..bb26f40493e6 100644
--- a/arch/arm/mach-ux500/board-mop500.c
+++ b/arch/arm/mach-ux500/board-mop500.c
@@ -204,7 +204,7 @@ static struct i2c_board_info __initdata mop500_i2c2_devices[] = {
         },
 };
 
-#define U8500_I2C_CONTROLLER(id, _slsu, _tft, _rft, clk, _sm) \
+#define U8500_I2C_CONTROLLER(id, _slsu, _tft, _rft, clk, t_out, _sm)    \
 static struct nmk_i2c_controller u8500_i2c##id##_data = { \
         /*                              \
          * slave data setup time, which is      \
@@ -219,19 +219,21 @@ static struct nmk_i2c_controller u8500_i2c##id##_data = { \
         .rft            = _rft,         \
         /* std. mode operation */       \
         .clk_freq       = clk,          \
+        /* Slave response timeout(ms) */\
+        .timeout        = t_out,        \
         .sm             = _sm,          \
 }
 
 /*
  * The board uses 4 i2c controllers, initialize all of
  * them with slave data setup time of 250 ns,
- * Tx & Rx FIFO threshold values as 1 and standard
+ * Tx & Rx FIFO threshold values as 8 and standard
  * mode of operation
  */
-U8500_I2C_CONTROLLER(0, 0xe, 1, 1, 100000, I2C_FREQ_MODE_STANDARD);
-U8500_I2C_CONTROLLER(1, 0xe, 1, 1, 100000, I2C_FREQ_MODE_STANDARD);
-U8500_I2C_CONTROLLER(2, 0xe, 1, 1, 100000, I2C_FREQ_MODE_STANDARD);
-U8500_I2C_CONTROLLER(3, 0xe, 1, 1, 100000, I2C_FREQ_MODE_STANDARD);
+U8500_I2C_CONTROLLER(0, 0xe, 1, 8, 100000, 200, I2C_FREQ_MODE_FAST);
+U8500_I2C_CONTROLLER(1, 0xe, 1, 8, 100000, 200, I2C_FREQ_MODE_FAST);
+U8500_I2C_CONTROLLER(2, 0xe, 1, 8, 100000, 200, I2C_FREQ_MODE_FAST);
+U8500_I2C_CONTROLLER(3, 0xe, 1, 8, 100000, 200, I2C_FREQ_MODE_FAST);
 
 static void __init mop500_i2c_init(void)
 {