Merge branch 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux

Pull i2c fixes from Wolfram Sang:
 "i2c has a bugfix and documentation improvements for you"

* 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
  Documentation: i2c: mention ACPI method for instantiating devices
  Documentation: i2c: describe devicetree method for instantiating devices
  i2c: mv64xxx: refactor message start to ensure proper initialization

1 files changed, 39 insertions, 2 deletions

diff --git a/Documentation/i2c/instantiating-devices b/Documentation/i2c/instantiating-devices
index c70e7a7638d1..0d85ac1935b7 100644
--- a/Documentation/i2c/instantiating-devices
+++ b/Documentation/i2c/instantiating-devices
@@ -8,8 +8,8 @@ reason, the kernel code must instantiate I2C devices explicitly. There are
 several ways to achieve this, depending on the context and requirements.
 
 
-Method 1: Declare the I2C devices by bus number
------------------------------------------------
+Method 1a: Declare the I2C devices by bus number
+------------------------------------------------
 
 This method is appropriate when the I2C bus is a system bus as is the case
 for many embedded systems. On such systems, each I2C bus has a number
@@ -51,6 +51,43 @@ The devices will be automatically unbound and destroyed when the I2C bus
 they sit on goes away (if ever.)
 
 
+Method 1b: Declare the I2C devices via devicetree
+-------------------------------------------------
+
+This method has the same implications as method 1a. The declaration of I2C
+devices is here done via devicetree as subnodes of the master controller.
+
+Example:
+
+        i2c1: i2c@400a0000 {
+                /* ... master properties skipped ... */
+                clock-frequency = <100000>;
+
+                flash@50 {
+                        compatible = "atmel,24c256";
+                        reg = <0x50>;
+                };
+
+                pca9532: gpio@60 {
+                        compatible = "nxp,pca9532";
+                        gpio-controller;
+                        #gpio-cells = <2>;
+                        reg = <0x60>;
+                };
+        };
+
+Here, two devices are attached to the bus using a speed of 100kHz. For
+additional properties which might be needed to set up the device, please refer
+to its devicetree documentation in Documentation/devicetree/bindings/.
+
+
+Method 1c: Declare the I2C devices via ACPI
+-------------------------------------------
+
+ACPI can also describe I2C devices. There is special documentation for this
+which is currently located at Documentation/acpi/enumeration.txt.
+
+
 Method 2: Instantiate the devices explicitly
 --------------------------------------------