Merge branch 'mpi-master' into wip-k-fmlpwip-k-fmlp

Conflicts:
	litmus/sched_cedf.c

2 files changed, 4 insertions, 4 deletions

diff --git a/Documentation/spi/pxa2xx b/Documentation/spi/pxa2xx
index 6bb916d57c95..493dada57372 100644
--- a/Documentation/spi/pxa2xx
+++ b/Documentation/spi/pxa2xx
@@ -19,7 +19,7 @@ Declaring PXA2xx Master Controllers
 -----------------------------------
 Typically a SPI master is defined in the arch/.../mach-*/board-*.c as a
 "platform device".  The master configuration is passed to the driver via a table
-found in arch/arm/mach-pxa/include/mach/pxa2xx_spi.h:
+found in include/linux/spi/pxa2xx_spi.h:
 
 struct pxa2xx_spi_master {
         enum pxa_ssp_type ssp_type;
@@ -94,7 +94,7 @@ using the "spi_board_info" structure found in "linux/spi/spi.h". See
 
 Each slave device attached to the PXA must provide slave specific configuration
 information via the structure "pxa2xx_spi_chip" found in
-"arch/arm/mach-pxa/include/mach/pxa2xx_spi.h".  The pxa2xx_spi master controller driver
+"include/linux/spi/pxa2xx_spi.h".  The pxa2xx_spi master controller driver
 will uses the configuration whenever the driver communicates with the slave
 device. All fields are optional.
 
@@ -143,7 +143,7 @@ configured to use SSPFRM instead.
 NOTE: the SPI driver cannot control the chip select if SSPFRM is used, so the
 chipselect is dropped after each spi_transfer.  Most devices need chip select
 asserted around the complete message.  Use SSPFRM as a GPIO (through cs_control)
-to accomodate these chips.
+to accommodate these chips.
 
 
 NSSP SLAVE SAMPLE
diff --git a/Documentation/spi/spi-lm70llp b/Documentation/spi/spi-lm70llp
index 34a9cfd746bd..463f6d01fa15 100644
--- a/Documentation/spi/spi-lm70llp
+++ b/Documentation/spi/spi-lm70llp
@@ -46,7 +46,7 @@ The hardware interfacing on the LM70 LLP eval board is as follows:
 
 Note that since the LM70 uses a "3-wire" variant of SPI, the SI/SO pin
 is connected to both pin D7 (as Master Out) and Select (as Master In)
-using an arrangment that lets either the parport or the LM70 pull the
+using an arrangement that lets either the parport or the LM70 pull the
 pin low.  This can't be shared with true SPI devices, but other 3-wire
 devices might share the same SI/SO pin.