leds: leds-ns2: set devm_gpio_request_one() flags param correctly

The devm_gpio_request_one() flags parameter was set to:

  GPIOF_DIR_OUT | gpio_get_value(template->cmd)

GPIOF_DIR_OUT and GPIOF_DIR_IN are defined as below:

  GPIOF_DIR_OUT   (0 << 0)
  GPIOF_DIR_IN    (1 << 0)

So, when 'gpio_get_value(template->cmd)' is 1, the gpio pin can
be set as input, instead of output.

To prevent this problem, GPIOF_OUT_INIT flags should be used when
using devm_gpio_request_one().

Same goes for 'gpio_get_value(template->slow)' case.

Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Bryan Wu <cooloney@gmail.com>

1 files changed, 4 insertions, 2 deletions

diff --git a/drivers/leds/leds-ns2.c b/drivers/leds/leds-ns2.c
index d978171c25b4..e02b3136273f 100644
--- a/drivers/leds/leds-ns2.c
+++ b/drivers/leds/leds-ns2.c
@@ -193,7 +193,8 @@ create_ns2_led(struct platform_device *pdev, struct ns2_led_data *led_dat,
         enum ns2_led_modes mode;
 
         ret = devm_gpio_request_one(&pdev->dev, template->cmd,
-                        GPIOF_DIR_OUT | gpio_get_value(template->cmd),
+                        gpio_get_value(template->cmd) ?
+                        GPIOF_OUT_INIT_HIGH : GPIOF_OUT_INIT_LOW,
                         template->name);
         if (ret) {
                 dev_err(&pdev->dev, "%s: failed to setup command GPIO\n",
@@ -202,7 +203,8 @@ create_ns2_led(struct platform_device *pdev, struct ns2_led_data *led_dat,
         }
 
         ret = devm_gpio_request_one(&pdev->dev, template->slow,
-                        GPIOF_DIR_OUT | gpio_get_value(template->slow),
+                        gpio_get_value(template->slow) ?
+                        GPIOF_OUT_INIT_HIGH : GPIOF_OUT_INIT_LOW,
                         template->name);
         if (ret) {
                 dev_err(&pdev->dev, "%s: failed to setup slow GPIO\n",