/*
* ChromeOS EC multi-function device (SPI)
*
* Copyright (C) 2012 Google, Inc
*
* This software is licensed under the terms of the GNU General Public
* License version 2, as published by the Free Software Foundation, and
* may be copied, distributed, and modified under those terms.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*/
#include <linux/delay.h>
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/mfd/cros_ec.h>
#include <linux/mfd/cros_ec_commands.h>
#include <linux/platform_device.h>
#include <linux/slab.h>
#include <linux/spi/spi.h>
/* The header byte, which follows the preamble */
#define EC_MSG_HEADER 0xec
/*
* Number of EC preamble bytes we read at a time. Since it takes
* about 400-500us for the EC to respond there is not a lot of
* point in tuning this. If the EC could respond faster then
* we could increase this so that might expect the preamble and
* message to occur in a single transaction. However, the maximum
* SPI transfer size is 256 bytes, so at 5MHz we need a response
* time of perhaps <320us (200 bytes / 1600 bits).
*/
#define EC_MSG_PREAMBLE_COUNT 32
/*
* We must get a response from the EC in 5ms. This is a very long
* time, but the flash write command can take 2-3ms. The EC command
* processing is currently not very fast (about 500us). We could
* look at speeding this up and making the flash write command a
* 'slow' command, requiring a GET_STATUS wait loop, like flash
* erase.
*/
#define EC_MSG_DEADLINE_MS 5
/*
* Time between raising the SPI chip select (for the end of a
* transaction) and dropping it again (for the next transaction).
* If we go too fast, the EC will miss the transaction. It seems
* that 50us is enough with the 16MHz STM32 EC.
*/
#define EC_SPI_RECOVERY_TIME_NS (50 * 1000)
/**
* struct cros_ec_spi - information about a SPI-connected EC
*
* @spi: SPI device we are connected to
* @last_transfer_ns: time that we last finished a transfer, or 0 if there
* if no record
*/
struct cros_ec_spi {
struct spi_device *spi;
s64 last_transfer_ns;
};
static void debug_packet(struct device *dev, const char *name, u8 *ptr,
int len)
{
#ifdef DEBUG
int i;
dev_dbg(dev, "%s: ", name);
for (i = 0; i < len; i++)
dev_cont(dev, " %02x", ptr[i]);
#endif
}
/**
* cros_ec_spi_receive_response - Receive a response from the EC.
*
* This function has two phases: reading the preamble bytes (since if we read
* data from the EC before it is ready to send, we just get preamble) and
* reading the actual message.
*
* The received data is placed into ec_dev->din.
*
* @ec_dev: ChromeOS EC device
* @need_len: Number of message bytes we need to read
*/
static int cros_ec_spi_receive_response(struct cros_ec_device *ec_dev,
int need_len)
{
struct cros_ec_spi *ec_spi = ec_dev->priv;
struct spi_transfer trans;
struct spi_message msg;
u8 *ptr, *end;
int ret;
unsigned long deadline;
int todo;
/* Receive data until we see the header byte */
deadline = jiffies + msecs_to_jiffies(EC_MSG_DEADLINE_MS);
do {
memset(&trans, '\0', sizeof(trans));
trans.cs_change = 1;
trans.rx_buf = ptr = ec_dev->din;
trans.len = EC_MSG_PREAMBLE_COUNT;
spi_message_init(&msg);
spi_message_add_tail(&trans, &msg);
ret = spi_sync(ec_spi->spi, &msg);
if (ret < 0) {
dev_err(ec_dev->dev, "spi transfer failed: %d\n", ret);
return ret;
}
for (end = ptr + EC_MSG_PREAMBLE_COUNT; ptr != end; ptr++) {
if (*ptr == EC_MSG_HEADER) {
dev_dbg(ec_dev->dev, "msg found at %zd\n",
ptr - ec_dev->din);
break;
}
}
if (time_after(jiffies, deadline)) {
dev_warn(ec_dev->dev, "EC failed to respond in time\n");
return -ETIMEDOUT;
}
} while (ptr == end);
/*
* ptr now points to the header byte. Copy any valid data to the
* start of our buffer
*/
todo = end - ++ptr;
BUG_ON(todo < 0 || todo > ec_dev->din_size);
todo = min(todo, need_len);
memmove(ec_dev->din, ptr, todo);
ptr = ec_dev->din + todo;
dev_dbg(ec_dev->dev, "need %d, got %d bytes from preamble\n",
need_len, todo);
need_len -= todo;
/* Receive data until we have it all */
while (need_len > 0) {
/*
* We can't support transfers larger than the SPI FIFO size
* unless we have DMA. We don't have DMA on the ISP SPI ports
* for Exynos. We need a way of asking SPI driver for
* maximum-supported transfer size.
*/
todo = min(need_len, 256);
dev_dbg(ec_dev->dev, "loop, todo=%d, need_len=%d, ptr=%zd\n",
todo, need_len, ptr - ec_dev->din);
memset(&trans, '\0', sizeof(trans));
trans.cs_change = 1;
trans.rx_buf = ptr;
trans.len = todo;
spi_message_init(&msg);
spi_message_add_tail(&trans, &msg);
/* send command to EC and read answer */
BUG_ON((u8 *)trans.rx_buf - ec_dev->din + todo >
ec_dev->din_size);
ret = spi_sync(ec_spi->spi, &msg);
if (ret < 0) {
dev_err(ec_dev->dev, "spi transfer failed: %d\n", ret);
return ret;
}
debug_packet(ec_dev->dev, "interim", ptr, todo);
ptr += todo;
need_len -= todo;
}
dev_dbg(ec_dev->dev, "loop done, ptr=%zd\n", ptr - ec_dev->din);
return 0;
}
/**
* cros_ec_command_spi_xfer - Transfer a message over SPI and receive the reply
*
* @ec_dev: ChromeOS EC device
* @ec_msg: Message to transfer
*/
static int cros_ec_command_spi_xfer(struct cros_ec_device *ec_dev,
struct cros_ec_msg *ec_msg)
{
struct cros_ec_spi *ec_spi = ec_dev->priv;
struct spi_transfer trans;
struct spi_message msg;
int i, len;
u8 *ptr;
int sum;
int ret = 0, final_ret;
struct timespec ts;
len = cros_ec_prepare_tx(ec_dev, ec_msg);
dev_dbg(ec_dev->dev, "prepared, len=%d\n", len);
/* If it's too soon to do another transaction, wait */
if (ec_spi->last_transfer_ns) {
struct timespec ts;
unsigned long delay; /* The delay completed so far */
ktime_get_ts(&ts);
delay = timespec_to_ns(&ts) - ec_spi->last_transfer_ns;
if (delay < EC_SPI_RECOVERY_TIME_NS)
ndelay(delay);
}
/* Transmit phase - send our message */
debug_packet(ec_dev->dev, "out", ec_dev->dout, len);
memset(&trans, '\0', sizeof(trans));
trans.tx_buf = ec_dev->dout;
trans.len = len;
trans.cs_change = 1;
spi_message_init(&msg);
spi_message_add_tail(&trans, &msg);
ret = spi_sync(ec_spi->spi, &msg);
/* Get the response */
if (!ret) {
ret = cros_ec_spi_receive_response(ec_dev,
ec_msg->in_len + EC_MSG_TX_PROTO_BYTES);
} else {
dev_err(ec_dev->dev, "spi transfer failed: %d\n", ret);
}
/* turn off CS */
spi_message_init(&msg);
final_ret = spi_sync(ec_spi->spi, &msg);
ktime_get_ts(&ts);
ec_spi->last_transfer_ns = timespec_to_ns(&ts);
if (!ret)
ret = final_ret;
if (ret < 0) {
dev_err(ec_dev->dev, "spi transfer failed: %d\n", ret);
return ret;
}
/* check response error code */
ptr = ec_dev->din;
if (ptr[0]) {
dev_warn(ec_dev->dev, "command 0x%02x returned an error %d\n",
ec_msg->cmd, ptr[0]);
debug_packet(ec_dev->dev, "in_err", ptr, len);
return -EINVAL;
}
len = ptr[1];
sum = ptr[0] + ptr[1];
if (len > ec_msg->in_len) {
dev_err(ec_dev->dev, "packet too long (%d bytes, expected %d)",
len, ec_msg->in_len);
return -ENOSPC;
}
/* copy response packet payload and compute checksum */
for (i = 0; i < len; i++) {
sum += ptr[i + 2];
if (ec_msg->in_len)
ec_msg->in_buf[i] = ptr[i + 2];
}
sum &= 0xff;
debug_packet(ec_dev->dev, "in", ptr, len + 3);
if (sum != ptr[len + 2]) {
dev_err(ec_dev->dev,
"bad packet checksum, expected %02x, got %02x\n",
sum, ptr[len + 2]);
return -EBADMSG;
}
return 0;
}
static int cros_ec_probe_spi(struct spi_device *spi)
{
struct device *dev = &spi->dev;
struct cros_ec_device *ec_dev;
struct cros_ec_spi *ec_spi;
int err;
spi->bits_per_word = 8;
spi->mode = SPI_MODE_0;
err = spi_setup(spi);
if (err < 0)
return err;
ec_spi = devm_kzalloc(dev, sizeof(*ec_spi), GFP_KERNEL);
if (ec_spi == NULL)
return -ENOMEM;
ec_spi->spi = spi;
ec_dev = devm_kzalloc(dev, sizeof(*ec_dev), GFP_KERNEL);
if (!ec_dev)
return -ENOMEM;
spi_set_drvdata(spi, ec_dev);
ec_dev->name = "SPI";
ec_dev->dev = dev;
ec_dev->priv = ec_spi;
ec_dev->irq = spi->irq;
ec_dev->command_xfer = cros_ec_command_spi_xfer;
ec_dev->ec_name = ec_spi->spi->modalias;
ec_dev->phys_name = dev_name(&ec_spi->spi->dev);
ec_dev->parent = &ec_spi->spi->dev;
ec_dev->din_size = EC_MSG_BYTES + EC_MSG_PREAMBLE_COUNT;
ec_dev->dout_size = EC_MSG_BYTES;
err = cros_ec_register(ec_dev);
if (err) {
dev_err(dev, "cannot register EC\n");
return err;
}
return 0;
}
static int cros_ec_remove_spi(struct spi_device *spi)
{
struct cros_ec_device *ec_dev;
ec_dev = spi_get_drvdata(spi);
cros_ec_remove(ec_dev);
return 0;
}
#ifdef CONFIG_PM_SLEEP
static int cros_ec_spi_suspend(struct device *dev)
{
struct cros_ec_device *ec_dev = dev_get_drvdata(dev);
return cros_ec_suspend(ec_dev);
}
static int cros_ec_spi_resume(struct device *dev)
{
struct cros_ec_device *ec_dev = dev_get_drvdata(dev);
return cros_ec_resume(ec_dev);
}
#endif
static SIMPLE_DEV_PM_OPS(cros_ec_spi_pm_ops, cros_ec_spi_suspend,
cros_ec_spi_resume);
static const struct spi_device_id cros_ec_spi_id[] = {
{ "cros-ec-spi", 0 },
{ }
};
MODULE_DEVICE_TABLE(spi, cros_ec_spi_id);
static struct spi_driver cros_ec_driver_spi = {
.driver = {
.name = "cros-ec-spi",
.owner = THIS_MODULE,
.pm = &cros_ec_spi_pm_ops,
},
.probe = cros_ec_probe_spi,
.remove = cros_ec_remove_spi,
.id_table = cros_ec_spi_id,
};
module_spi_driver(cros_ec_driver_spi);
MODULE_LICENSE("GPL");
MODULE_DESCRIPTION("ChromeOS EC multi function device (SPI)");
