* Power Management Controller
Properties:
- compatible: "fsl,<chip>-pmc".
"fsl,mpc8349-pmc" should be listed for any chip whose PMC is
compatible. "fsl,mpc8313-pmc" should also be listed for any chip
whose PMC is compatible, and implies deep-sleep capability.
"fsl,mpc8548-pmc" should be listed for any chip whose PMC is
compatible. "fsl,mpc8536-pmc" should also be listed for any chip
whose PMC is compatible, and implies deep-sleep capability.
"fsl,mpc8641d-pmc" should be listed for any chip whose PMC is
compatible; all statements below that apply to "fsl,mpc8548-pmc" also
apply to "fsl,mpc8641d-pmc".
Compatibility does not include bit assignments in SCCR/PMCDR/DEVDISR; these
bit assignments are indicated via the sleep specifier in each device's
sleep property.
- reg: For devices compatible with "fsl,mpc8349-pmc", the first resource
is the PMC block, and the second resource is the Clock Configuration
block.
For devices compatible with "fsl,mpc8548-pmc", the first resource
is a 32-byte block beginning with DEVDISR.
- interrupts: For "fsl,mpc8349-pmc"-compatible devices, the first
resource is the PMC block interrupt.
- fsl,mpc8313-wakeup-timer: For "fsl,mpc8313-pmc"-compatible devices,
this is a phandle to an "fsl,gtm" node on which timer 4 can be used as
a wakeup source from deep sleep.
Sleep specifiers:
fsl,mpc8349-pmc: Sleep specifiers consist of one cell. For each bit
that is set in the cell, the corresponding bit in SCCR will be saved
and cleared on suspend, and restored on resume. This sleep controller
supports disabling and resuming devices at any time.
fsl,mpc8536-pmc: Sleep specifiers consist of three cells, the third of
which will be ORed into PMCDR upon suspend, and cleared from PMCDR
upon resume. The first two cells are as described for fsl,mpc8578-pmc.
This sleep controller only supports disabling devices during system
sleep, or permanently.
fsl,mpc8548-pmc: Sleep specifiers consist of one or two cells, the
first of which will be ORed into DEVDISR (and the second into
DEVDISR2, if present -- this cell should be zero or absent if the
hardware does not have DEVDISR2) upon a request for permanent device
disabling. This sleep controller does not support configuring devices
to disable during system sleep (unless supported by another compatible
match), or dynamically.
Example:
power@b00 {
compatible = "fsl,mpc8313-pmc", "fsl,mpc8349-pmc";
reg = <0xb00 0x100 0xa00 0x100>;
interrupts = <80 8>;
};
