ARM Broadcom STB platforms Device Tree Bindings
-----------------------------------------------
Boards with Broadcom Brahma15 ARM-based BCMxxxx (generally BCM7xxx variants)
SoC shall have the following DT organization:
Required root node properties:
- compatible: "brcm,bcm<chip_id>", "brcm,brcmstb"
example:
/ {
#address-cells = <2>;
#size-cells = <2>;
model = "Broadcom STB (bcm7445)";
compatible = "brcm,bcm7445", "brcm,brcmstb";
Further, syscon nodes that map platform-specific registers used for general
system control is required:
- compatible: "brcm,bcm<chip_id>-sun-top-ctrl", "syscon"
- compatible: "brcm,bcm<chip_id>-hif-cpubiuctrl", "syscon"
- compatible: "brcm,bcm<chip_id>-hif-continuation", "syscon"
example:
rdb {
#address-cells = <1>;
#size-cells = <1>;
compatible = "simple-bus";
ranges = <0 0x00 0xf0000000 0x1000000>;
sun_top_ctrl: syscon@404000 {
compatible = "brcm,bcm7445-sun-top-ctrl", "syscon";
reg = <0x404000 0x51c>;
};
hif_cpubiuctrl: syscon@3e2400 {
compatible = "brcm,bcm7445-hif-cpubiuctrl", "syscon";
reg = <0x3e2400 0x5b4>;
};
hif_continuation: syscon@452000 {
compatible = "brcm,bcm7445-hif-continuation", "syscon";
reg = <0x452000 0x100>;
};
};
Lastly, nodes that allow for support of SMP initialization and reboot are
required:
smpboot
-------
Required properties:
- compatible
The string "brcm,brcmstb-smpboot".
- syscon-cpu
A phandle / integer array property which lets the BSP know the location
of certain CPU power-on registers.
The layout of the property is as follows:
o a phandle to the "hif_cpubiuctrl" syscon node
o offset to the base CPU power zone register
o offset to the base CPU reset register
- syscon-cont
A phandle pointing to the syscon node which describes the CPU boot
continuation registers.
o a phandle to the "hif_continuation" syscon node
example:
smpboot {
compatible = "brcm,brcmstb-smpboot";
syscon-cpu = <&hif_cpubiuctrl 0x88 0x178>;
syscon-cont = <&hif_continuation>;
};
reboot
-------
Required properties
- compatible
The string property "brcm,brcmstb-reboot".
- syscon
A phandle / integer array that points to the syscon node which describes
the general system reset registers.
o a phandle to "sun_top_ctrl"
o offset to the "reset source enable" register
o offset to the "software master reset" register
example:
reboot {
compatible = "brcm,brcmstb-reboot";
syscon = <&sun_top_ctrl 0x304 0x308>;
};
