1 files changed, 0 insertions, 39 deletions

diff --git a/arch/avr32/include/asm/atmel-mci.h b/arch/avr32/include/asm/atmel-mci.h
deleted file mode 100644
index 59f3fadd0b6..00000000000
--- a/arch/avr32/include/asm/atmel-mci.h
+++ /dev/null
@@ -1,39 +0,0 @@
-#ifndef __ASM_AVR32_ATMEL_MCI_H
-#define __ASM_AVR32_ATMEL_MCI_H
-
-#define ATMEL_MCI_MAX_NR_SLOTS  2
-
-struct dma_slave;
-
-/**
- * struct mci_slot_pdata - board-specific per-slot configuration
- * @bus_width: Number of data lines wired up the slot
- * @detect_pin: GPIO pin wired to the card detect switch
- * @wp_pin: GPIO pin wired to the write protect sensor
- *
- * If a given slot is not present on the board, @bus_width should be
- * set to 0. The other fields are ignored in this case.
- *
- * Any pins that aren't available should be set to a negative value.
- *
- * Note that support for multiple slots is experimental -- some cards
- * might get upset if we don't get the clock management exactly right.
- * But in most cases, it should work just fine.
- */
-struct mci_slot_pdata {
-        unsigned int            bus_width;
-        int                     detect_pin;
-        int                     wp_pin;
-};
-
-/**
- * struct mci_platform_data - board-specific MMC/SDcard configuration
- * @dma_slave: DMA slave interface to use in data transfers, or NULL.
- * @slot: Per-slot configuration data.
- */
-struct mci_platform_data {
-        struct dma_slave        *dma_slave;
-        struct mci_slot_pdata   slot[ATMEL_MCI_MAX_NR_SLOTS];
-};
-
-#endif /* __ASM_AVR32_ATMEL_MCI_H */