1 files changed, 63 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/mtd/fsl-upm-nand.txt b/Documentation/devicetree/bindings/mtd/fsl-upm-nand.txt
new file mode 100644
index 00000000000..a48b2cadc7f
--- /dev/null
+++ b/Documentation/devicetree/bindings/mtd/fsl-upm-nand.txt
@@ -0,0 +1,63 @@
+Freescale Localbus UPM programmed to work with NAND flash
+
+Required properties:
+- compatible : "fsl,upm-nand".
+- reg : should specify localbus chip select and size used for the chip.
+- fsl,upm-addr-offset : UPM pattern offset for the address latch.
+- fsl,upm-cmd-offset : UPM pattern offset for the command latch.
+
+Optional properties:
+- fsl,upm-wait-flags : add chip-dependent short delays after running the
+        UPM pattern (0x1), after writing a data byte (0x2) or after
+        writing out a buffer (0x4).
+- fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support.
+        The corresponding address lines are used to select the chip.
+- gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
+        (R/B#). For multi-chip devices, "n" GPIO definitions are required
+        according to the number of chips.
+- chip-delay : chip dependent delay for transfering data from array to
+        read registers (tR). Required if property "gpios" is not used
+        (R/B# pins not connected).
+
+Examples:
+
+upm@1,0 {
+        compatible = "fsl,upm-nand";
+        reg = <1 0 1>;
+        fsl,upm-addr-offset = <16>;
+        fsl,upm-cmd-offset = <8>;
+        gpios = <&qe_pio_e 18 0>;
+
+        flash {
+                #address-cells = <1>;
+                #size-cells = <1>;
+                compatible = "...";
+
+                partition@0 {
+                        ...
+                };
+        };
+};
+
+upm@3,0 {
+        #address-cells = <0>;
+        #size-cells = <0>;
+        compatible = "tqc,tqm8548-upm-nand", "fsl,upm-nand";
+        reg = <3 0x0 0x800>;
+        fsl,upm-addr-offset = <0x10>;
+        fsl,upm-cmd-offset = <0x08>;
+        /* Multi-chip NAND device */
+        fsl,upm-addr-line-cs-offsets = <0x0 0x200>;
+        fsl,upm-wait-flags = <0x5>;
+        chip-delay = <25>; // in micro-seconds
+
+        nand@0 {
+                #address-cells = <1>;
+                #size-cells = <1>;
+
+                partition@0 {
+                            label = "fs";
+                            reg = <0x00000000 0x10000000>;
+                };
+        };
+};