trivial: Kconfig: .ko is normally not included in module names

.ko is normally not included in Kconfig help, make it consistent.

Signed-off-by: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>

1 files changed, 2 insertions, 2 deletions

diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
index 890936d0275..f3276897859 100644
--- a/drivers/mtd/nand/Kconfig
+++ b/drivers/mtd/nand/Kconfig
@@ -260,7 +260,7 @@ config MTD_NAND_BASLER_EXCITE
         help
           This enables the driver for the NAND flash device found on the
           Basler eXcite Smart Camera. If built as a module, the driver
-          will be named "excite_nandflash.ko".
+          will be named excite_nandflash.
 
 config MTD_NAND_CAFE
         tristate "NAND support for OLPC CAFÉ chip"
@@ -282,7 +282,7 @@ config MTD_NAND_CS553X
           controller is enabled for NAND, and currently requires that
           the controller be in MMIO mode.
 
-          If you say "m", the module will be called "cs553x_nand.ko".
+          If you say "m", the module will be called cs553x_nand.
 
 config MTD_NAND_ATMEL
         tristate "Support for NAND Flash / SmartMedia on AT91 and AVR32"