ARM: mx5/mx53_evk: Use gpio_request_one in mx53_evk_fec_reset

Current code inside mx53_evk_fec_reset uses gpio_direction_output with initial value of the GPIO and also sets
the GPIO value via gpio_set_value right after. This is not needed.

By using gpio_request_one it is possible to set the direction and initial value in one shot.

Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Acked-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 2 insertions, 3 deletions

diff --git a/arch/arm/mach-mx5/board-mx53_evk.c b/arch/arm/mach-mx5/board-mx53_evk.c
index 7b5735c5ea5..d771999a167 100644
--- a/arch/arm/mach-mx5/board-mx53_evk.c
+++ b/arch/arm/mach-mx5/board-mx53_evk.c
@@ -82,13 +82,12 @@ static inline void mx53_evk_fec_reset(void)
         int ret;
 
         /* reset FEC PHY */
-        ret = gpio_request(SMD_FEC_PHY_RST, "fec-phy-reset");
+        ret = gpio_request_one(SMD_FEC_PHY_RST, GPIOF_OUT_INIT_LOW,
+                                                        "fec-phy-reset");
         if (ret) {
                 printk(KERN_ERR"failed to get GPIO_FEC_PHY_RESET: %d\n", ret);
                 return;
         }
-        gpio_direction_output(SMD_FEC_PHY_RST, 0);
-        gpio_set_value(SMD_FEC_PHY_RST, 0);
         msleep(1);
         gpio_set_value(SMD_FEC_PHY_RST, 1);
 }