3 files changed, 64 insertions, 18 deletions

diff --git a/arch/mips/sibyte/sb1250/time.c b/arch/mips/sibyte/sb1250/time.c
index adc0b5271a0..1588f6debd9 100644
--- a/arch/mips/sibyte/sb1250/time.c
+++ b/arch/mips/sibyte/sb1250/time.c
@@ -47,23 +47,51 @@
 #define IMR_IP3_VAL     K_INT_MAP_I1
 #define IMR_IP4_VAL     K_INT_MAP_I2
 
+#define SB1250_HPT_NUM          3
+#define SB1250_HPT_VALUE        M_SCD_TIMER_CNT /* max value */
+#define SB1250_HPT_SHIFT        ((sizeof(unsigned int)*8)-V_SCD_TIMER_WIDTH)
+
+
 extern int sb1250_steal_irq(int irq);
 
+static unsigned int sb1250_hpt_read(void);
+static void sb1250_hpt_init(unsigned int);
+
+static unsigned int hpt_offset;
+
+void __init sb1250_hpt_setup(void)
+{
+        int cpu = smp_processor_id();
+
+        if (!cpu) {
+                /* Setup hpt using timer #3 but do not enable irq for it */
+                __raw_writeq(0, IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM, R_SCD_TIMER_CFG)));
+                __raw_writeq(SB1250_HPT_VALUE,
+                             IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM, R_SCD_TIMER_INIT)));
+                __raw_writeq(M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS,
+                             IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM, R_SCD_TIMER_CFG)));
+
+                /*
+                 * we need to fill 32 bits, so just use the upper 23 bits and pretend
+                 * the timer is going 512Mhz instead of 1Mhz
+                 */
+                mips_hpt_frequency = V_SCD_TIMER_FREQ << SB1250_HPT_SHIFT;
+                mips_hpt_init = sb1250_hpt_init;
+                mips_hpt_read = sb1250_hpt_read;
+        }
+}
+
+
 void sb1250_time_init(void)
 {
         int cpu = smp_processor_id();
         int irq = K_INT_TIMER_0+cpu;
 
-        /* Only have 4 general purpose timers */
-        if (cpu > 3) {
+        /* Only have 4 general purpose timers, and we use last one as hpt */
+        if (cpu > 2) {
                 BUG();
         }
 
-        if (!cpu) {
-                /* Use our own gettimeoffset() routine */
-                do_gettimeoffset = sb1250_gettimeoffset;
-        }
-
         sb1250_mask_irq(cpu, irq);
 
         /* Map the timer interrupt to ip[4] of this cpu */
@@ -103,7 +131,7 @@ void sb1250_timer_interrupt(struct pt_regs *regs)
         int cpu = smp_processor_id();
         int irq = K_INT_TIMER_0 + cpu;
 
-        /* Reset the timer */
+        /* ACK interrupt */
         ____raw_writeq(M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS,
                        IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG)));
 
@@ -122,15 +150,26 @@ void sb1250_timer_interrupt(struct pt_regs *regs)
 }
 
 /*
- * We use our own do_gettimeoffset() instead of the generic one,
- * because the generic one does not work for SMP case.
- * In addition, since we use general timer 0 for system time,
- * we can get accurate intra-jiffy offset without calibration.
+ * The HPT is free running from SB1250_HPT_VALUE down to 0 then starts over
+ * again. There's no easy way to set to a specific value so store init value
+ * in hpt_offset and subtract each time.
+ *
+ * Note: Timer isn't full 32bits so shift it into the upper part making
+ *       it appear to run at a higher frequency.
  */
-unsigned long sb1250_gettimeoffset(void)
+static unsigned int sb1250_hpt_read(void)
 {
-        unsigned long count =
-                __raw_readq(IOADDR(A_SCD_TIMER_REGISTER(0, R_SCD_TIMER_CNT)));
+        unsigned int count;
 
-        return 1000000/HZ - count;
- }
+        count = G_SCD_TIMER_CNT(__raw_readq(IOADDR(A_SCD_TIMER_REGISTER(SB1250_HPT_NUM, R_SCD_TIMER_CNT))));
+
+        count = (SB1250_HPT_VALUE - count) << SB1250_HPT_SHIFT;
+
+        return count - hpt_offset;
+}
+
+static void sb1250_hpt_init(unsigned int count)
+{
+        hpt_offset = count;
+        return;
+}
diff --git a/arch/mips/sibyte/swarm/setup.c b/arch/mips/sibyte/swarm/setup.c
index b614ca0ddb6..b661d2425a3 100644
--- a/arch/mips/sibyte/swarm/setup.c
+++ b/arch/mips/sibyte/swarm/setup.c
@@ -70,6 +70,12 @@ const char *get_system_type(void)
         return "SiByte " SIBYTE_BOARD_NAME;
 }
 
+void __init swarm_time_init(void)
+{
+        /* Setup HPT */
+        sb1250_hpt_setup();
+}
+
 void __init swarm_timer_setup(struct irqaction *irq)
 {
         /*
@@ -109,6 +115,7 @@ void __init plat_setup(void)
 
         panic_timeout = 5;  /* For debug.  */
 
+        board_time_init = swarm_time_init;
         board_timer_setup = swarm_timer_setup;
         board_be_handler = swarm_be_handler;
 
diff --git a/include/asm-mips/sibyte/sb1250.h b/include/asm-mips/sibyte/sb1250.h
index a474c29cd70..b09e16c93ca 100644
--- a/include/asm-mips/sibyte/sb1250.h
+++ b/include/asm-mips/sibyte/sb1250.h
@@ -45,8 +45,8 @@ extern unsigned int soc_type;
 extern unsigned int periph_rev;
 extern unsigned int zbbus_mhz;
 
+extern void sb1250_hpt_setup(void);
 extern void sb1250_time_init(void);
-extern unsigned long sb1250_gettimeoffset(void);
 extern void sb1250_mask_irq(int cpu, int irq);
 extern void sb1250_unmask_irq(int cpu, int irq);
 extern void sb1250_smp_finish(void);