cfg80211: keep track of supported interface modes

It is obviously good for userspace to know up front which
interface modes a given piece of hardware might support (even
if adding such an interface might fail later because of
concurrency issues), so let's make cfg80211 aware of that.
For good measure, disallow adding interfaces in all other
modes so drivers don't forget to announce support for one mode
when they add it.

Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: Stephen Blackheath <tramp.enshrine.stephen@blacksapphire.com>
Signed-off-by: Ivo van Doorn <IvDoorn@gmail.com>
Signed-off-by: Luis R. Rodriguez <lrodriguez@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

1 files changed, 7 insertions, 0 deletions

diff --git a/drivers/net/wireless/b43/main.c b/drivers/net/wireless/b43/main.c
index 63bafc2f3f0..2d915c1a82a 100644
--- a/drivers/net/wireless/b43/main.c
+++ b/drivers/net/wireless/b43/main.c
@@ -4569,6 +4569,13 @@ static int b43_wireless_init(struct ssb_device *dev)
                     IEEE80211_HW_SIGNAL_DBM |
                     IEEE80211_HW_NOISE_DBM;
 
+        hw->wiphy->interface_modes =
+                BIT(NL80211_IFTYPE_AP) |
+                BIT(NL80211_IFTYPE_MESH_POINT) |
+                BIT(NL80211_IFTYPE_STATION) |
+                BIT(NL80211_IFTYPE_WDS) |
+                BIT(NL80211_IFTYPE_ADHOC);
+
         hw->queues = b43_modparam_qos ? 4 : 1;
         SET_IEEE80211_DEV(hw, dev->dev);
         if (is_valid_ether_addr(sprom->et1mac))