aboutsummaryrefslogtreecommitdiffstats
path: root/drivers/net/wireless/ti/wlcore/wlcore.h
Commit message (Expand)AuthorAge
* wl18xx: add time sync configuration apiGuy Mishol2016-09-03
* cfg80211: remove enum ieee80211_bandJohannes Berg2016-04-12
* wlcore/wl18xx: add radar_debug_mode handlingEliad Peller2016-03-10
* wlcore/wl18xx: fw logger over sdioShahar Patury2015-12-31
* wlcore: align reg_ch_conf_last[] to 64bitGuodong Xu2015-09-29
* wl18xx: add dynamic fw tracesGuy Mishol2015-08-06
* wlcore: set irq_trigger in board files instead of hiding behind a quirkLuciano Coelho2015-03-19
* wlcore: add dfs region to reg domain update cmdGuy Mishol2015-01-09
* wlcore: add dfs master restart callsEliad Peller2015-01-09
* wl18xx: add radar detection implementationEliad Peller2015-01-09
* wlcore: enable sleep during AP mode operationKobi L2015-01-09
* wlcore: add ability to reduce FW interrupts during suspendRam Amrani2015-01-09
* wlcore/wl18xx: handle rc updates in a separate workEliad Peller2015-01-09
* wlcore/wl18xx/wl12xx: convert bitmaps to unsigned longsEliad Peller2014-07-15
* wlcore/wl18xx: add smart config commandsEliad Peller2014-07-15
* mac80211: split sched scan IEsDavid Spinadel2014-06-25
* wlcore: wl18xx: allow CCK rates for AP modeArik Nemtsov2014-02-13
* wlcore/wl12xx/wl18xx: configure iface_combinations per-hwEliad Peller2014-02-13
* wlcore/wl12xx/wl18xx: configure max_stations per-hwEliad Peller2014-02-13
* wlcore/wl12xx/wl18xx: configure num_links per-hwEliad Peller2014-02-13
* wlcore/wl12xx/wl18xx: simplify fw_status handlingEliad Peller2014-02-13
* wlcore: memset wl->rx_filter_enabled to zero after recoveryNadim Zubidat2014-02-13
* wlcore/wl18xx/wl12xx: FW log params per chip archIgal Chernobelsky2013-10-23
* wlcore: add ap_event_maskEliad Peller2013-10-23
* wlcore: ROC on AP channel before auth replyArik Nemtsov2013-09-30
* wlcore: set max num of Rx BA sessions per chipIgal Chernobelsky2013-03-25
* wlcore: remove unused set_power methodLuciano Coelho2013-02-08
* Merge branch 'wl12xx-next' into for-linvilleLuciano Coelho2013-01-18
|\
| * wlcore: Always pass DMA-able buffers to mmc functionsIdo Yariv2012-12-11
| * wlcore: use separate HW queue for each AC in each vifArik Nemtsov2012-12-11
| * wlcore: use link count for single-STA-PSM optimizationArik Nemtsov2012-12-11
| * wlcore/wl18xx: change priority calculations for linksArik Nemtsov2012-12-11
| * wlcore: add ACX_PEER_CAP commandEliad Peller2012-12-11
| * wlcore: improved Tx scheduling algorithmArik Nemtsov2012-12-05
| * wlcore: restore default channel configurationVictor Goldenshtein2012-12-05
| * wlcore: remove WLCORE_QUIRK_NO_ELPEliad Peller2012-12-04
| * wlcore/wl12xx: make sure session id is always zero for APArik Nemtsov2012-12-04
| * wlcore/wl12xx/wl18xx: verify multi-role and single-role fw versionsLuciano Coelho2012-12-04
| * wlcore: change way of checking the firmware versionLuciano Coelho2012-12-04
| * wlcore/wl12xx: move wl12xx chip ID defines to the lower driverLuciano Coelho2012-12-04
| * wlcore: gather information about firmware stabilityLuciano Coelho2012-12-04
| * wlcore/wl18xx/wl12xx: separate channel count between chipsArik Nemtsov2012-12-04
| * wlcore: use new set bandwidth command to adjusting channel BWArik Nemtsov2012-11-28
| * wlcore: call ieee80211_sched_scan_stopped on interface removalEliad Peller2012-11-28
| * wlcore: add new reg-domain configuration commandVictor Goldenshtein2012-11-28
| * wlcore: save session_id per-linkEliad Peller2012-11-27
| * wlcore: update events enum/struct to new fw apiEliad Peller2012-11-27
| * wlcore: update channel_switch/stop_channel_switch commandsEliad Peller2012-11-27
| * wl18xx: increase MAX_CHANNELS_5GHZEliad Peller2012-11-27
| * wlcore: split 18xx and 12xx scan mechanismEliad Peller2012-11-27
generated by cgit v1.2.2 (git 2.25.0) at 2025-04-09 00:32:16 -0400