sh_eth: convert pr_*() to netdev_*() calls

Convert pr_*() to netdev_*() calls as the latter provide info on a device.

Suggested-by: Joe Perches <joe@perches.com>
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 5 insertions, 4 deletions

diff --git a/drivers/net/ethernet/renesas/sh_eth.c b/drivers/net/ethernet/renesas/sh_eth.c
index 8d8315bb0cea..62f79fedd36f 100644
--- a/drivers/net/ethernet/renesas/sh_eth.c
+++ b/drivers/net/ethernet/renesas/sh_eth.c
@@ -400,7 +400,8 @@ static void sh_eth_select_mii(struct net_device *ndev)
                 value = 0x0;
                 break;
         default:
-                pr_warn("PHY interface mode was not setup. Set to MII.\n");
+                netdev_warn(ndev,
+                            "PHY interface mode was not setup. Set to MII.\n");
                 value = 0x1;
                 break;
         }
@@ -854,7 +855,7 @@ static int sh_eth_check_reset(struct net_device *ndev)
                 cnt--;
         }
         if (cnt <= 0) {
-                pr_err("Device reset failed\n");
+                netdev_err(ndev, "Device reset failed\n");
                 ret = -ETIMEDOUT;
         }
         return ret;
@@ -2924,8 +2925,8 @@ static int sh_eth_drv_probe(struct platform_device *pdev)
         }
 
         /* print device information */
-        pr_info("Base address at 0x%x, %pM, IRQ %d.\n",
-                (u32)ndev->base_addr, ndev->dev_addr, ndev->irq);
+        netdev_info(ndev, "Base address at 0x%x, %pM, IRQ %d.\n",
+                    (u32)ndev->base_addr, ndev->dev_addr, ndev->irq);
 
         platform_set_drvdata(pdev, ndev);