signal: Explicitly call force_sig_fault on current

Update the calls of force_sig_fault that pass in a variable that is
set to current earlier to explicitly use current.

This is to make the next change that removes the task parameter
from force_sig_fault easier to verify.

Signed-off-by: "Eric W. Biederman" <ebiederm@xmission.com>

1 files changed, 2 insertions, 2 deletions

diff --git a/arch/mips/mm/fault.c b/arch/mips/mm/fault.c
index 73d8a0f0b810..e63abd492f65 100644
--- a/arch/mips/mm/fault.c
+++ b/arch/mips/mm/fault.c
@@ -223,7 +223,7 @@ bad_area_nosemaphore:
                         pr_cont("\n");
                 }
                 current->thread.trap_nr = (regs->cp0_cause >> 2) & 0x1f;
-                force_sig_fault(SIGSEGV, si_code, (void __user *)address, tsk);
+                force_sig_fault(SIGSEGV, si_code, (void __user *)address, current);
                 return;
         }
 
@@ -279,7 +279,7 @@ do_sigbus:
 #endif
         current->thread.trap_nr = (regs->cp0_cause >> 2) & 0x1f;
         tsk->thread.cp0_badvaddr = address;
-        force_sig_fault(SIGBUS, BUS_ADRERR, (void __user *)address, tsk);
+        force_sig_fault(SIGBUS, BUS_ADRERR, (void __user *)address, current);
 
         return;
 #ifndef CONFIG_64BIT