signal: Explicitly call force_sig_fault on current

Update the calls of force_sig_fault that pass in a variable that is
set to current earlier to explicitly use current.

This is to make the next change that removes the task parameter
from force_sig_fault easier to verify.

Signed-off-by: "Eric W. Biederman" <ebiederm@xmission.com>

1 files changed, 2 insertions, 2 deletions

diff --git a/arch/arc/mm/fault.c b/arch/arc/mm/fault.c
index 8df1638259f3..d5d4758d7e75 100644
--- a/arch/arc/mm/fault.c
+++ b/arch/arc/mm/fault.c
@@ -202,7 +202,7 @@ bad_area_nosemaphore:
         /* User mode accesses just cause a SIGSEGV */
         if (user_mode(regs)) {
                 tsk->thread.fault_address = address;
-                force_sig_fault(SIGSEGV, si_code, (void __user *)address, tsk);
+                force_sig_fault(SIGSEGV, si_code, (void __user *)address, current);
                 return;
         }
 
@@ -237,5 +237,5 @@ do_sigbus:
                 goto no_context;
 
         tsk->thread.fault_address = address;
-        force_sig_fault(SIGBUS, BUS_ADRERR, (void __user *)address, tsk);
+        force_sig_fault(SIGBUS, BUS_ADRERR, (void __user *)address, current);
 }