mmc: fix mmc mode selection for HS-DDR and higher

When IS_ERR_VALUE was removed from the mmc core code, it was replaced
with a simple not-zero check. This does not work, as the value checked
is the return value for mmc_select_bus_width, which returns the set
bit width on success. This made eMMC modes higher than HS-DDR unusable.

Fix this by checking for a positive return value instead.

Fixes: 287980e49ffc ("remove lots of IS_ERR_VALUE abuses")
Cc: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Chen-Yu Tsai <wens@csie.org>
Acked-by: Hans de Goede <hdegoede@redhat.com>
Reviewed-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Acked-by: Jaehoon Chung <jh80.chung@samsung.com>
Reviewed-by: Shawn Lin <shawn.lin@rock-chips.com>
Tested-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Tested-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

1 files changed, 2 insertions, 2 deletions

diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
index c984321d1881..5d438ad3ee32 100644
--- a/drivers/mmc/core/mmc.c
+++ b/drivers/mmc/core/mmc.c
@@ -1276,7 +1276,7 @@ static int mmc_select_hs200(struct mmc_card *card)
          * switch to HS200 mode if bus width is set successfully.
          */
         err = mmc_select_bus_width(card);
-        if (!err) {
+        if (err >= 0) {
                 val = EXT_CSD_TIMING_HS200 |
                       card->drive_strength << EXT_CSD_DRV_STR_SHIFT;
                 err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
@@ -1583,7 +1583,7 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr,
         } else if (mmc_card_hs(card)) {
                 /* Select the desired bus width optionally */
                 err = mmc_select_bus_width(card);
-                if (!err) {
+                if (err >= 0) {
                         err = mmc_select_hs_ddr(card);
                         if (err)
                                 goto free_card;