spi/pxa2xx: fix incorrect SW mode chipselect setting for BayTrail LPSS SPI

It was observed that after module removal followed by insertion,
the SW mode chipselect is not properly set. Thus causing transfer
failure due to incorrect CS toggling.

Signed-off-by: Chew, Chiau Ee <chiau.ee.chew@intel.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Mark Brown <broonie@linaro.org>

1 files changed, 6 insertions, 2 deletions

diff --git a/drivers/spi/spi-pxa2xx.c b/drivers/spi/spi-pxa2xx.c
index a98df7eeb42d..fe792106bdc5 100644
--- a/drivers/spi/spi-pxa2xx.c
+++ b/drivers/spi/spi-pxa2xx.c
@@ -118,6 +118,7 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
          */
         orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
 
+        /* Test SPI_CS_CONTROL_SW_MODE bit enabling */
         value = orig | SPI_CS_CONTROL_SW_MODE;
         writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
         value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
@@ -126,10 +127,13 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
                 goto detection_done;
         }
 
-        value &= ~SPI_CS_CONTROL_SW_MODE;
+        orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
+
+        /* Test SPI_CS_CONTROL_SW_MODE bit disabling */
+        value = orig & ~SPI_CS_CONTROL_SW_MODE;
         writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
         value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
-        if (value != orig) {
+        if (value != (orig & ~SPI_CS_CONTROL_SW_MODE)) {
                 offset = 0x800;
                 goto detection_done;
         }