blob: c6b9cbc7230a5bb121feb288dd9ce3228c9f984d (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
|
/*
* omap_udc.h -- for omap 3.2 udc, with OTG support
*
* 2004 (C) Texas Instruments, Inc.
* 2004 (C) David Brownell
*/
/*
* USB device/endpoint management registers
*/
#define UDC_REG(offset) __REG16(UDC_BASE + (offset))
#define UDC_REV_REG UDC_REG(0x0) /* Revision */
#define UDC_EP_NUM_REG UDC_REG(0x4) /* Which endpoint */
# define UDC_SETUP_SEL (1 << 6)
# define UDC_EP_SEL (1 << 5)
# define UDC_EP_DIR (1 << 4)
/* low 4 bits for endpoint number */
#define UDC_DATA_REG UDC_REG(0x08) /* Endpoint FIFO */
#define UDC_CTRL_REG UDC_REG(0x0C) /* Endpoint control */
# define UDC_CLR_HALT (1 << 7)
# define UDC_SET_HALT (1 << 6)
# define UDC_CLRDATA_TOGGLE (1 << 3)
# define UDC_SET_FIFO_EN (1 << 2)
# define UDC_CLR_EP (1 << 1)
# define UDC_RESET_EP (1 << 0)
#define UDC_STAT_FLG_REG UDC_REG(0x10) /* Endpoint status */
# define UDC_NO_RXPACKET (1 << 15)
# define UDC_MISS_IN (1 << 14)
# define UDC_DATA_FLUSH (1 << 13)
# define UDC_ISO_ERR (1 << 12)
# define UDC_ISO_FIFO_EMPTY (1 << 9)
# define UDC_ISO_FIFO_FULL (1 << 8)
# define UDC_EP_HALTED (1 << 6)
# define UDC_STALL (1 << 5)
# define UDC_NAK (1 << 4)
# define UDC_ACK (1 << 3)
# define UDC_FIFO_EN (1 << 2)
# define UDC_NON_ISO_FIFO_EMPTY (1 << 1)
# define UDC_NON_ISO_FIFO_FULL (1 << 0)
#define UDC_RXFSTAT_REG UDC_REG(0x14) /* OUT bytecount */
#define UDC_SYSCON1_REG UDC_REG(0x18) /* System config 1 */
# define UDC_CFG_LOCK (1 << 8)
# define UDC_DATA_ENDIAN (1 << 7)
# define UDC_DMA_ENDIAN (1 << 6)
# define UDC_NAK_EN (1 << 4)
# define UDC_AUTODECODE_DIS (1 << 3)
# define UDC_SELF_PWR (1 << 2)
# define UDC_SOFF_DIS (1 << 1)
# define UDC_PULLUP_EN (1 << 0)
#define UDC_SYSCON2_REG UDC_REG(0x1C) /* System config 2 */
# define UDC_RMT_WKP (1 << 6)
# define UDC_STALL_CMD (1 << 5)
# define UDC_DEV_CFG (1 << 3)
# define UDC_CLR_CFG (1 << 2)
#define UDC_DEVSTAT_REG UDC_REG(0x20) /* Device status */
# define UDC_B_HNP_ENABLE (1 << 9)
# define UDC_A_HNP_SUPPORT (1 << 8)
# define UDC_A_ALT_HNP_SUPPORT (1 << 7)
# define UDC_R_WK_OK (1 << 6)
# define UDC_USB_RESET (1 << 5)
# define UDC_SUS (1 << 4)
# define UDC_CFG (1 << 3)
# define UDC_ADD (1 << 2)
# define UDC_DEF (1 << 1)
# define UDC_ATT (1 << 0)
#define UDC_SOF_REG UDC_REG(0x24) /* Start of frame */
# define UDC_FT_LOCK (1 << 12)
# define UDC_TS_OK (1 << 11)
# define UDC_TS 0x03ff
#define UDC_IRQ_EN_REG UDC_REG(0x28) /* Interrupt enable */
# define UDC_SOF_IE (1 << 7)
# define UDC_EPN_RX_IE (1 << 5)
# define UDC_EPN_TX_IE (1 << 4)
# define UDC_DS_CHG_IE (1 << 3)
# define UDC_EP0_IE (1 << 0)
#define UDC_DMA_IRQ_EN_REG UDC_REG(0x2C) /* DMA irq enable */
/* rx/tx dma channels numbered 1-3 not 0-2 */
# define UDC_TX_DONE_IE(n) (1 << (4 * (n) - 2))
# define UDC_RX_CNT_IE(n) (1 << (4 * (n) - 3))
# define UDC_RX_EOT_IE(n) (1 << (4 * (n) - 4))
#define UDC_IRQ_SRC_REG UDC_REG(0x30) /* Interrupt source */
# define UDC_TXN_DONE (1 << 10)
# define UDC_RXN_CNT (1 << 9)
# define UDC_RXN_EOT (1 << 8)
# define UDC_SOF (1 << 7)
# define UDC_EPN_RX (1 << 5)
# define UDC_EPN_TX (1 << 4)
# define UDC_DS_CHG (1 << 3)
# define UDC_SETUP (1 << 2)
# define UDC_EP0_RX (1 << 1)
# define UDC_EP0_TX (1 << 0)
# define UDC_IRQ_SRC_MASK 0x7bf
#define UDC_EPN_STAT_REG UDC_REG(0x34) /* EP irq status */
#define UDC_DMAN_STAT_REG UDC_REG(0x38) /* DMA irq status */
# define UDC_DMA_RX_SB (1 << 12)
# define UDC_DMA_RX_SRC(x) (((x)>>8) & 0xf)
# define UDC_DMA_TX_SRC(x) (((x)>>0) & 0xf)
/* DMA configuration registers: up to three channels in each direction. */
#define UDC_RXDMA_CFG_REG UDC_REG(0x40) /* 3 eps for RX DMA */
# define UDC_DMA_REQ (1 << 12)
#define UDC_TXDMA_CFG_REG UDC_REG(0x44) /* 3 eps for TX DMA */
#define UDC_DATA_DMA_REG UDC_REG(0x48) /* rx/tx fifo addr */
/* rx/tx dma control, numbering channels 1-3 not 0-2 */
#define UDC_TXDMA_REG(chan) UDC_REG(0x50 - 4 + 4 * (chan))
# define UDC_TXN_EOT (1 << 15) /* bytes vs packets */
# define UDC_TXN_START (1 << 14) /* start transfer */
# define UDC_TXN_TSC 0x03ff /* units in xfer */
#define UDC_RXDMA_REG(chan) UDC_REG(0x60 - 4 + 4 * (chan))
# define UDC_RXN_STOP (1 << 15) /* enable EOT irq */
# define UDC_RXN_TC 0x00ff /* packets in xfer */
/*
* Endpoint configuration registers (used before CFG_LOCK is set)
* UDC_EP_TX_REG(0) is unused
*/
#define UDC_EP_RX_REG(endpoint) UDC_REG(0x80 + (endpoint)*4)
# define UDC_EPN_RX_VALID (1 << 15)
# define UDC_EPN_RX_DB (1 << 14)
/* buffer size in bits 13, 12 */
# define UDC_EPN_RX_ISO (1 << 11)
/* buffer pointer in low 11 bits */
#define UDC_EP_TX_REG(endpoint) UDC_REG(0xc0 + (endpoint)*4)
/* same bitfields as in RX_REG */
/*-------------------------------------------------------------------------*/
struct omap_req {
struct usb_request req;
struct list_head queue;
unsigned dma_bytes;
unsigned mapped:1;
};
struct omap_ep {
struct usb_ep ep;
struct list_head queue;
unsigned long irqs;
struct list_head iso;
const struct usb_endpoint_descriptor *desc;
char name[14];
u16 maxpacket;
u8 bEndpointAddress;
u8 bmAttributes;
unsigned double_buf:1;
unsigned stopped:1;
unsigned fnf:1;
unsigned has_dma:1;
u8 ackwait;
u8 dma_channel;
u16 dma_counter;
int lch;
struct omap_udc *udc;
struct timer_list timer;
};
struct omap_udc {
struct usb_gadget gadget;
struct usb_gadget_driver *driver;
spinlock_t lock;
struct omap_ep ep[32];
u16 devstat;
u16 clr_halt;
struct otg_transceiver *transceiver;
struct list_head iso;
unsigned softconnect:1;
unsigned vbus_active:1;
unsigned ep0_pending:1;
unsigned ep0_in:1;
unsigned ep0_set_config:1;
unsigned ep0_reset_config:1;
unsigned ep0_setup:1;
struct completion *done;
struct clk *dc_clk;
struct clk *hhc_clk;
unsigned clk_requested:1;
};
/*-------------------------------------------------------------------------*/
#ifdef VERBOSE
# define VDBG DBG
#else
# define VDBG(stuff...) do{}while(0)
#endif
#define ERR(stuff...) pr_err("udc: " stuff)
#define WARN(stuff...) pr_warning("udc: " stuff)
#define INFO(stuff...) pr_info("udc: " stuff)
#define DBG(stuff...) pr_debug("udc: " stuff)
/*-------------------------------------------------------------------------*/
#define MOD_CONF_CTRL_0_REG __REG32(MOD_CONF_CTRL_0)
#define VBUS_W2FC_1510 (1 << 17) /* 0 gpio0, 1 dvdd2 pin */
#define FUNC_MUX_CTRL_0_REG __REG32(FUNC_MUX_CTRL_0)
#define VBUS_CTRL_1510 (1 << 19) /* 1 connected (software) */
#define VBUS_MODE_1510 (1 << 18) /* 0 hardware, 1 software */
#define HMC_1510 ((MOD_CONF_CTRL_0_REG >> 1) & 0x3f)
#define HMC_1610 (OTG_SYSCON_2_REG & 0x3f)
#define HMC (cpu_is_omap15xx() ? HMC_1510 : HMC_1610)
|
