From f5c044e53a6b319776c7140b22fee9be3bc1f758 Mon Sep 17 00:00:00 2001 From: "John W. Linville" Date: Fri, 30 Apr 2010 15:37:00 -0400 Subject: mac80211: remove deprecated noise field from ieee80211_rx_status Also remove associated IEEE80211_HW_NOISE_DBM from ieee80211_hw_flags. Signed-off-by: John W. Linville --- include/net/mac80211.h | 8 +------- 1 file changed, 1 insertion(+), 7 deletions(-) (limited to 'include/net') diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 2879c8ef5571..00502b1a9e38 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -560,7 +560,6 @@ enum mac80211_rx_flags { * @signal: signal strength when receiving this frame, either in dBm, in dB or * unspecified depending on the hardware capabilities flags * @IEEE80211_HW_SIGNAL_* - * @noise: noise when receiving this frame, in dBm (DEPRECATED). * @antenna: antenna used * @rate_idx: index of data rate into band's supported rates or MCS index if * HT rates are use (RX_FLAG_HT) @@ -571,7 +570,6 @@ struct ieee80211_rx_status { enum ieee80211_band band; int freq; int signal; - int noise __deprecated; int antenna; int rate_idx; int flag; @@ -934,10 +932,6 @@ enum ieee80211_tkip_key_type { * one milliwatt. This is the preferred method since it is standardized * between different devices. @max_signal does not need to be set. * - * @IEEE80211_HW_NOISE_DBM: - * Hardware can provide noise (radio interference) values in units dBm, - * decibel difference from one milliwatt. - * * @IEEE80211_HW_SPECTRUM_MGMT: * Hardware supports spectrum management defined in 802.11h * Measurement, Channel Switch, Quieting, TPC @@ -1001,7 +995,7 @@ enum ieee80211_hw_flags { IEEE80211_HW_2GHZ_SHORT_PREAMBLE_INCAPABLE = 1<<4, IEEE80211_HW_SIGNAL_UNSPEC = 1<<5, IEEE80211_HW_SIGNAL_DBM = 1<<6, - IEEE80211_HW_NOISE_DBM = 1<<7, + /* use this hole */ IEEE80211_HW_SPECTRUM_MGMT = 1<<8, IEEE80211_HW_AMPDU_AGGREGATION = 1<<9, IEEE80211_HW_SUPPORTS_PS = 1<<10, -- cgit v1.2.2