From 781c7b129b1beb876905f7212927aa0ee1b022e5 Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Fri, 7 May 2010 08:40:53 +0000 Subject: spi/pl022: add support for the PL023 derivate This adds support for a further ST variant of the PL022 called PL023. Some differences in the control registers due to being stripped down to SPI mode only, and a new clock feedback sample delay config setting is available. Signed-off-by: Linus Walleij Signed-off-by: Grant Likely --- drivers/spi/amba-pl022.c | 90 +++++++++++++++++++++++++++++++++++++++--------- 1 file changed, 74 insertions(+), 16 deletions(-) (limited to 'drivers/spi') diff --git a/drivers/spi/amba-pl022.c b/drivers/spi/amba-pl022.c index 65092171cec3..c75831c1deda 100644 --- a/drivers/spi/amba-pl022.c +++ b/drivers/spi/amba-pl022.c @@ -135,6 +135,8 @@ #define SSP_CR1_MASK_MWAIT_ST (0x1UL << 6) #define SSP_CR1_MASK_RXIFLSEL_ST (0x7UL << 7) #define SSP_CR1_MASK_TXIFLSEL_ST (0x7UL << 10) +/* This one is only in the PL023 variant */ +#define SSP_CR1_MASK_FBCLKDEL_ST (0x7UL << 13) /* * SSP Status Register - SSP_SR @@ -317,12 +319,14 @@ enum ssp_writing { * @unidir: supports unidirection transfers * @extended_cr: 32 bit wide control register 0 with extra * features and extra features in CR1 as found in the ST variants + * @pl023: supports a subset of the ST extensions called "PL023" */ struct vendor_data { int fifodepth; int max_bpw; bool unidir; bool extended_cr; + bool pl023; }; /** @@ -541,11 +545,6 @@ static void restore_state(struct pl022 *pl022) writew(CLEAR_ALL_INTERRUPTS, SSP_ICR(pl022->virtbase)); } -/** - * load_ssp_default_config - Load default configuration for SSP - * @pl022: SSP driver private data structure - */ - /* * Default SSP Register Values */ @@ -568,6 +567,14 @@ static void restore_state(struct pl022 *pl022) GEN_MASK_BITS(SSP_INTERFACE_MOTOROLA_SPI, SSP_CR0_MASK_FRF_ST, 21) \ ) +/* The PL023 version is slightly different again */ +#define DEFAULT_SSP_REG_CR0_ST_PL023 ( \ + GEN_MASK_BITS(SSP_DATA_BITS_12, SSP_CR0_MASK_DSS_ST, 0) | \ + GEN_MASK_BITS(SSP_CLK_POL_IDLE_LOW, SSP_CR0_MASK_SPO, 6) | \ + GEN_MASK_BITS(SSP_CLK_SECOND_EDGE, SSP_CR0_MASK_SPH, 7) | \ + GEN_MASK_BITS(SSP_DEFAULT_CLKRATE, SSP_CR0_MASK_SCR, 8) \ +) + #define DEFAULT_SSP_REG_CR1 ( \ GEN_MASK_BITS(LOOPBACK_DISABLED, SSP_CR1_MASK_LBM, 0) | \ GEN_MASK_BITS(SSP_DISABLED, SSP_CR1_MASK_SSE, 1) | \ @@ -585,6 +592,20 @@ static void restore_state(struct pl022 *pl022) GEN_MASK_BITS(SSP_TX_1_OR_MORE_EMPTY_LOC, SSP_CR1_MASK_TXIFLSEL_ST, 10) \ ) +/* + * The PL023 variant has further differences: no loopback mode, no microwire + * support, and a new clock feedback delay setting. + */ +#define DEFAULT_SSP_REG_CR1_ST_PL023 ( \ + GEN_MASK_BITS(SSP_DISABLED, SSP_CR1_MASK_SSE, 1) | \ + GEN_MASK_BITS(SSP_MASTER, SSP_CR1_MASK_MS, 2) | \ + GEN_MASK_BITS(DO_NOT_DRIVE_TX, SSP_CR1_MASK_SOD, 3) | \ + GEN_MASK_BITS(SSP_RX_MSB, SSP_CR1_MASK_RENDN_ST, 4) | \ + GEN_MASK_BITS(SSP_TX_MSB, SSP_CR1_MASK_TENDN_ST, 5) | \ + GEN_MASK_BITS(SSP_RX_1_OR_MORE_ELEM, SSP_CR1_MASK_RXIFLSEL_ST, 7) | \ + GEN_MASK_BITS(SSP_TX_1_OR_MORE_EMPTY_LOC, SSP_CR1_MASK_TXIFLSEL_ST, 10) | \ + GEN_MASK_BITS(SSP_FEEDBACK_CLK_DELAY_NONE, SSP_CR1_MASK_FBCLKDEL_ST, 13) \ +) #define DEFAULT_SSP_REG_CPSR ( \ GEN_MASK_BITS(SSP_DEFAULT_PRESCALE, SSP_CPSR_MASK_CPSDVSR, 0) \ @@ -595,10 +616,16 @@ static void restore_state(struct pl022 *pl022) GEN_MASK_BITS(SSP_DMA_DISABLED, SSP_DMACR_MASK_TXDMAE, 1) \ ) - +/** + * load_ssp_default_config - Load default configuration for SSP + * @pl022: SSP driver private data structure + */ static void load_ssp_default_config(struct pl022 *pl022) { - if (pl022->vendor->extended_cr) { + if (pl022->vendor->pl023) { + writel(DEFAULT_SSP_REG_CR0_ST_PL023, SSP_CR0(pl022->virtbase)); + writew(DEFAULT_SSP_REG_CR1_ST_PL023, SSP_CR1(pl022->virtbase)); + } else if (pl022->vendor->extended_cr) { writel(DEFAULT_SSP_REG_CR0_ST, SSP_CR0(pl022->virtbase)); writew(DEFAULT_SSP_REG_CR1_ST, SSP_CR1(pl022->virtbase)); } else { @@ -1629,20 +1656,27 @@ static int pl022_setup(struct spi_device *spi) /* Special setup for the ST micro extended control registers */ if (pl022->vendor->extended_cr) { + if (pl022->vendor->pl023) { + /* These bits are only in the PL023 */ + SSP_WRITE_BITS(chip->cr1, chip_info->clkdelay, + SSP_CR1_MASK_FBCLKDEL_ST, 13); + } else { + /* These bits are in the PL022 but not PL023 */ + SSP_WRITE_BITS(chip->cr0, chip_info->duplex, + SSP_CR0_MASK_HALFDUP_ST, 5); + SSP_WRITE_BITS(chip->cr0, chip_info->ctrl_len, + SSP_CR0_MASK_CSS_ST, 16); + SSP_WRITE_BITS(chip->cr0, chip_info->iface, + SSP_CR0_MASK_FRF_ST, 21); + SSP_WRITE_BITS(chip->cr1, chip_info->wait_state, + SSP_CR1_MASK_MWAIT_ST, 6); + } SSP_WRITE_BITS(chip->cr0, chip_info->data_size, SSP_CR0_MASK_DSS_ST, 0); - SSP_WRITE_BITS(chip->cr0, chip_info->duplex, - SSP_CR0_MASK_HALFDUP_ST, 5); - SSP_WRITE_BITS(chip->cr0, chip_info->ctrl_len, - SSP_CR0_MASK_CSS_ST, 16); - SSP_WRITE_BITS(chip->cr0, chip_info->iface, - SSP_CR0_MASK_FRF_ST, 21); SSP_WRITE_BITS(chip->cr1, chip_info->endian_rx, SSP_CR1_MASK_RENDN_ST, 4); SSP_WRITE_BITS(chip->cr1, chip_info->endian_tx, SSP_CR1_MASK_TENDN_ST, 5); - SSP_WRITE_BITS(chip->cr1, chip_info->wait_state, - SSP_CR1_MASK_MWAIT_ST, 6); SSP_WRITE_BITS(chip->cr1, chip_info->rx_lev_trig, SSP_CR1_MASK_RXIFLSEL_ST, 7); SSP_WRITE_BITS(chip->cr1, chip_info->tx_lev_trig, @@ -1657,7 +1691,9 @@ static int pl022_setup(struct spi_device *spi) SSP_WRITE_BITS(chip->cr0, chip_info->clk_pol, SSP_CR0_MASK_SPO, 6); SSP_WRITE_BITS(chip->cr0, chip_info->clk_phase, SSP_CR0_MASK_SPH, 7); SSP_WRITE_BITS(chip->cr0, chip_info->clk_freq.scr, SSP_CR0_MASK_SCR, 8); - SSP_WRITE_BITS(chip->cr1, chip_info->lbm, SSP_CR1_MASK_LBM, 0); + /* Loopback is available on all versions except PL023 */ + if (!pl022->vendor->pl023) + SSP_WRITE_BITS(chip->cr1, chip_info->lbm, SSP_CR1_MASK_LBM, 0); SSP_WRITE_BITS(chip->cr1, SSP_DISABLED, SSP_CR1_MASK_SSE, 1); SSP_WRITE_BITS(chip->cr1, chip_info->hierarchy, SSP_CR1_MASK_MS, 2); SSP_WRITE_BITS(chip->cr1, chip_info->slave_tx_disable, SSP_CR1_MASK_SOD, 3); @@ -1874,6 +1910,7 @@ static struct vendor_data vendor_arm = { .max_bpw = 16, .unidir = false, .extended_cr = false, + .pl023 = false, }; @@ -1882,6 +1919,15 @@ static struct vendor_data vendor_st = { .max_bpw = 32, .unidir = false, .extended_cr = true, + .pl023 = false, +}; + +static struct vendor_data vendor_st_pl023 = { + .fifodepth = 32, + .max_bpw = 32, + .unidir = false, + .extended_cr = true, + .pl023 = true, }; static struct amba_id pl022_ids[] = { @@ -1903,6 +1949,18 @@ static struct amba_id pl022_ids[] = { .mask = 0xffffffff, .data = &vendor_st, }, + { + /* + * ST-Ericsson derivative "PL023" (this is not + * an official ARM number), this is a PL022 SSP block + * stripped to SPI mode only, it has 32bit wide + * and 32 locations deep TX/RX FIFO but no extended + * CR0/CR1 register + */ + .id = 0x00080023, + .mask = 0xffffffff, + .data = &vendor_st_pl023, + }, { 0, 0 }, }; -- cgit v1.2.2