From 28735a7253a6c24364765e80a5428b4a151fccc2 Mon Sep 17 00:00:00 2001 From: David Brownell Date: Fri, 16 Mar 2007 13:38:14 -0800 Subject: [PATCH] gpio_direction_output() needs an initial value It's been pointed out that output GPIOs should have an initial value, to avoid signal glitching ... among other things, it can be some time before a driver is ready. This patch corrects that oversight, fixing - documentation - platforms supporting the GPIO interface - users of that call (just one for now, others are pending) There's only one user of this call for now since most platforms are still using non-generic GPIO setup code, which in most cases already couples the initial value with its "set output mode" request. Note that most platforms are clear about the hardware letting the output value be set before the pin direction is changed, but the s3c241x docs are vague on that topic ... so those chips might not avoid the glitches. Signed-off-by: David Brownell Acked-by: Andrew Victor Acked-by: Milan Svoboda Acked-by: Haavard Skinnemoen Cc: Russell King Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- drivers/spi/atmel_spi.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) (limited to 'drivers/spi') diff --git a/drivers/spi/atmel_spi.c b/drivers/spi/atmel_spi.c index 6fa260d1a9be..66e7bc985797 100644 --- a/drivers/spi/atmel_spi.c +++ b/drivers/spi/atmel_spi.c @@ -425,7 +425,7 @@ static int atmel_spi_setup(struct spi_device *spi) if (ret) return ret; spi->controller_state = (void *)npcs_pin; - gpio_direction_output(npcs_pin); + gpio_direction_output(npcs_pin, !(spi->mode & SPI_CS_HIGH)); } dev_dbg(&spi->dev, -- cgit v1.2.2