From 8d38a5b2fab1397d35ba1c92828a91b77ce9f865 Mon Sep 17 00:00:00 2001 From: Arnd Bergmann Date: Tue, 13 Feb 2007 21:35:38 +0100 Subject: [POWERPC] Open Firmware serial port driver This can be used for serial ports that are connected to an OF platform bus but are not autodetected by the lecacy serial support. It will automatically take over devices that come from the legacy serial detection, which usually is only one device. In some cases, rtas may be set up to use the serial port in the firmware, which allows easier debugging before probing the serial ports. In this case, the "used-by-rtas" property must be set by the firmware. This patch also adds code to the legacy serial driver to check for this. Signed-off-by: Arnd Bergmann Signed-off-by: Paul Mackerras --- drivers/serial/Kconfig | 10 ++++++++++ 1 file changed, 10 insertions(+) (limited to 'drivers/serial/Kconfig') diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig index 5cc6b91f8408..d0edbaacb1f7 100644 --- a/drivers/serial/Kconfig +++ b/drivers/serial/Kconfig @@ -999,4 +999,14 @@ config SERIAL_NETX_CONSOLE If you have enabled the serial port on the Motorola IMX CPU you can make it the console by answering Y to this option. +config SERIAL_OF_PLATFORM + tristate "Serial port on Open Firmware platform bus" + depends on PPC_OF + depends on SERIAL_8250 + help + If you have a PowerPC based system that has serial ports + on a platform specific bus, you should enable this option. + Currently, only 8250 compatible ports are supported, but + others can easily be added. + endmenu -- cgit v1.2.2