From cda2109a26eb6fa58acfeae878eed87492480eae Mon Sep 17 00:00:00 2001 From: Grygorii Strashko Date: Fri, 7 Jun 2013 21:46:07 +0300 Subject: i2c: omap: query STP always when NACK is received According to I2C specification the NACK should be handled as folowing: "When SDA remains HIGH during this ninth clock pulse, this is defined as the Not Acknowledge signal. The master can then gene rate either a STOP condition to abort the transfer, or a repeated START condition to start a new transfer." [http://www.nxp.com/documents/user_manual/UM10204.pdf] The same is recomened by TI I2C wiki: http://processors.wiki.ti.com/index.php/I2C_Tips Currently, the OMAP I2C driver interrupts I2C trunsfer in case of NACK, but It queries Stop condition OMAP_I2C_CON_REG.STP=1 only if NACK has been received during the last message transmitting/recieving. This may lead to stuck Bus in "Bus Busy" until I2C IP reset (idle/enable). Hence, fix it by querying Stop condition (STP) always when NACK is received. Signed-off-by: Grygorii Strashko Acked-by: Hein Tibosch Acked-by: Felipe Balbi Signed-off-by: Wolfram Sang --- drivers/i2c/busses/i2c-omap.c | 9 ++++----- 1 file changed, 4 insertions(+), 5 deletions(-) (limited to 'drivers/i2c') diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c index d09512e4f488..c6db76ec5a22 100644 --- a/drivers/i2c/busses/i2c-omap.c +++ b/drivers/i2c/busses/i2c-omap.c @@ -615,11 +615,10 @@ static int omap_i2c_xfer_msg(struct i2c_adapter *adap, if (dev->cmd_err & OMAP_I2C_STAT_NACK) { if (msg->flags & I2C_M_IGNORE_NAK) return 0; - if (stop) { - w = omap_i2c_read_reg(dev, OMAP_I2C_CON_REG); - w |= OMAP_I2C_CON_STP; - omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, w); - } + + w = omap_i2c_read_reg(dev, OMAP_I2C_CON_REG); + w |= OMAP_I2C_CON_STP; + omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, w); return -EREMOTEIO; } return -EIO; -- cgit v1.2.2