From 68942edb09f69b6e09522d1d346665eb3aadde49 Mon Sep 17 00:00:00 2001 From: Kevin Hilman Date: Mon, 5 Mar 2012 15:10:04 -0800 Subject: gpio/omap: fix wakeups on level-triggered GPIOs While both level- and edge-triggered GPIOs are capable of generating interrupts, only edge-triggered GPIOs are capable of generating a module-level wakeup to the PRCM (c.f. 34xx NDA TRM section 25.5.3.2.) In order to ensure that devices using level-triggered GPIOs as interrupts can also cause wakeups (e.g. from idle), this patch enables edge-triggering for wakeup-enabled, level-triggered GPIOs when a GPIO bank is runtime-suspended (which also happens during idle.) This fixes a problem found in GPMC-connected network cards with GPIO interrupts (e.g. smsc911x on Zoom3, Overo, ...) where network booting with NFSroot was very slow since the GPIO IRQs used by the NIC were not generating PRCM wakeups, and thus not waking the system from idle. NOTE: until v3.3, this boot-time problem was somewhat masked because the UART init prevented WFI during boot until the full serial driver was available. Preventing WFI allowed regular GPIO interrupts to fire and this problem was not seen. After the UART runtime PM cleanups, we no longer avoid WFI during boot, so GPIO IRQs that were not causing wakeups resulted in very slow IRQ response times. Tested on platforms using level-triggered GPIOs for network IRQs using the SMSC911x NIC: 3530/Overo and 3630/Zoom3. Reported-by: Tony Lindgren Tested-by: Tarun Kanti DebBarma Tested-by: Tony Lindgren Signed-off-by: Kevin Hilman Signed-off-by: Grant Likely --- drivers/gpio/gpio-omap.c | 34 ++++++++++++++++++++++++++++++++++ 1 file changed, 34 insertions(+) (limited to 'drivers/gpio') diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c index afef0f7c8adf..c48de8ffe9ef 100644 --- a/drivers/gpio/gpio-omap.c +++ b/drivers/gpio/gpio-omap.c @@ -1206,8 +1206,30 @@ static int omap_gpio_runtime_suspend(struct device *dev) struct gpio_bank *bank = platform_get_drvdata(pdev); u32 l1 = 0, l2 = 0; unsigned long flags; + u32 wake_low, wake_hi; spin_lock_irqsave(&bank->lock, flags); + + /* + * Only edges can generate a wakeup event to the PRCM. + * + * Therefore, ensure any wake-up capable GPIOs have + * edge-detection enabled before going idle to ensure a wakeup + * to the PRCM is generated on a GPIO transition. (c.f. 34xx + * NDA TRM 25.5.3.1) + * + * The normal values will be restored upon ->runtime_resume() + * by writing back the values saved in bank->context. + */ + wake_low = bank->context.leveldetect0 & bank->context.wake_en; + if (wake_low) + __raw_writel(wake_low | bank->context.fallingdetect, + bank->base + bank->regs->fallingdetect); + wake_hi = bank->context.leveldetect1 & bank->context.wake_en; + if (wake_hi) + __raw_writel(wake_hi | bank->context.risingdetect, + bank->base + bank->regs->risingdetect); + if (bank->power_mode != OFF_MODE) { bank->power_mode = 0; goto update_gpio_context_count; @@ -1256,6 +1278,18 @@ static int omap_gpio_runtime_resume(struct device *dev) spin_lock_irqsave(&bank->lock, flags); _gpio_dbck_enable(bank); + + /* + * In ->runtime_suspend(), level-triggered, wakeup-enabled + * GPIOs were set to edge trigger also in order to be able to + * generate a PRCM wakeup. Here we restore the + * pre-runtime_suspend() values for edge triggering. + */ + __raw_writel(bank->context.fallingdetect, + bank->base + bank->regs->fallingdetect); + __raw_writel(bank->context.risingdetect, + bank->base + bank->regs->risingdetect); + if (!bank->enabled_non_wakeup_gpios || !bank->workaround_enabled) { spin_unlock_irqrestore(&bank->lock, flags); return 0; -- cgit v1.2.2