From d6da3511d6b558d0b017777b61dc08b8fbc06ea4 Mon Sep 17 00:00:00 2001 From: Tomasz Grobelny Date: Thu, 4 Sep 2008 07:30:19 +0200 Subject: dccp: Policy-based packet dequeueing infrastructure This patch adds a generic infrastructure for policy-based dequeueing of TX packets and provides two policies: * a simple FIFO policy (which is the default) and * a priority based policy (set via socket options). Both policies honour the tx_qlen sysctl for the maximum size of the write queue (can be overridden via socket options). The priority policy uses skb->priority internally to assign an u32 priority identifier, using the same ranking as SO_PRIORITY. The skb->priority field is set to 0 when the packet leaves DCCP. The priority is supplied as ancillary data using cmsg(3), the patch also provides the requisite parsing routines. Signed-off-by: Tomasz Grobelny Signed-off-by: Gerrit Renker --- Documentation/networking/dccp.txt | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+) (limited to 'Documentation/networking') diff --git a/Documentation/networking/dccp.txt b/Documentation/networking/dccp.txt index b132e4a3cf0f..fcfc12534428 100644 --- a/Documentation/networking/dccp.txt +++ b/Documentation/networking/dccp.txt @@ -45,6 +45,25 @@ http://linux-net.osdl.org/index.php/DCCP_Testing#Experimental_DCCP_source_tree Socket options ============== +DCCP_SOCKOPT_QPOLICY_ID sets the dequeuing policy for outgoing packets. It takes +a policy ID as argument and can only be set before the connection (i.e. changes +during an established connection are not supported). Currently, two policies are +defined: the "simple" policy (DCCPQ_POLICY_SIMPLE), which does nothing special, +and a priority-based variant (DCCPQ_POLICY_PRIO). The latter allows to pass an +u32 priority value as ancillary data to sendmsg(), where higher numbers indicate +a higher packet priority (similar to SO_PRIORITY). This ancillary data needs to +be formatted using a cmsg(3) message header filled in as follows: + cmsg->cmsg_level = SOL_DCCP; + cmsg->cmsg_type = DCCP_SCM_PRIORITY; + cmsg->cmsg_len = CMSG_LEN(sizeof(uint32_t)); /* or CMSG_LEN(4) */ + +DCCP_SOCKOPT_QPOLICY_TXQLEN sets the maximum length of the output queue. A zero +value is always interpreted as unbounded queue length. If different from zero, +the interpretation of this parameter depends on the current dequeuing policy +(see above): the "simple" policy will enforce a fixed queue size by returning +EAGAIN, whereas the "prio" policy enforces a fixed queue length by dropping the +lowest-priority packet first. The default value for this parameter is +initialised from /proc/sys/net/dccp/default/tx_qlen. DCCP_SOCKOPT_SERVICE sets the service. The specification mandates use of service codes (RFC 4340, sec. 8.1.2); if this socket option is not set, -- cgit v1.2.2