From 13098cf05a430464f50ffac73cfa2c467768410d Mon Sep 17 00:00:00 2001 From: Ludovic Desroches Date: Fri, 4 Oct 2013 10:46:51 +0200 Subject: dma: atmel-dma: correct typo in the device tree bindings documentation The value to set ASAP mode for FIFO configuration is 2 instead of 1. Signed-off-by: Ludovic Desroches Acked-by: Nicolas Ferre Signed-off-by: Vinod Koul --- Documentation/devicetree/bindings/dma/atmel-dma.txt | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) (limited to 'Documentation/devicetree') diff --git a/Documentation/devicetree/bindings/dma/atmel-dma.txt b/Documentation/devicetree/bindings/dma/atmel-dma.txt index e1f343c7a34b..f69bcf5a6343 100644 --- a/Documentation/devicetree/bindings/dma/atmel-dma.txt +++ b/Documentation/devicetree/bindings/dma/atmel-dma.txt @@ -28,7 +28,7 @@ The three cells in order are: dependent: - bit 7-0: peripheral identifier for the hardware handshaking interface. The identifier can be different for tx and rx. - - bit 11-8: FIFO configuration. 0 for half FIFO, 1 for ALAP, 1 for ASAP. + - bit 11-8: FIFO configuration. 0 for half FIFO, 1 for ALAP, 2 for ASAP. Example: -- cgit v1.2.2 From c3d68d8dd4f8d44579e2f0d121990f288c4a0e9a Mon Sep 17 00:00:00 2001 From: Hongbo Zhang Date: Thu, 26 Sep 2013 17:33:41 +0800 Subject: DMA: Freescale: revise device tree binding document This patch updates the discription of each type of DMA controller and its channels, it is preparation for adding another new DMA controller binding, it also fixes some defects of indent for text alignment at the same time. Signed-off-by: Hongbo Zhang Acked-by: Mark Rutland Signed-off-by: Vinod Koul --- .../devicetree/bindings/powerpc/fsl/dma.txt | 68 ++++++++++------------ 1 file changed, 31 insertions(+), 37 deletions(-) (limited to 'Documentation/devicetree') diff --git a/Documentation/devicetree/bindings/powerpc/fsl/dma.txt b/Documentation/devicetree/bindings/powerpc/fsl/dma.txt index 2a4b4bce6110..05841689c4a3 100644 --- a/Documentation/devicetree/bindings/powerpc/fsl/dma.txt +++ b/Documentation/devicetree/bindings/powerpc/fsl/dma.txt @@ -1,33 +1,30 @@ -* Freescale 83xx DMA Controller +* Freescale DMA Controllers -Freescale PowerPC 83xx have on chip general purpose DMA controllers. +** Freescale Elo DMA Controller + This is a little-endian 4-channel DMA controller, used in Freescale mpc83xx + series chips such as mpc8315, mpc8349, mpc8379 etc. Required properties: -- compatible : compatible list, contains 2 entries, first is - "fsl,CHIP-dma", where CHIP is the processor - (mpc8349, mpc8360, etc.) and the second is - "fsl,elo-dma" -- reg : -- ranges : Should be defined as specified in 1) to describe the - DMA controller channels. +- compatible : must include "fsl,elo-dma" +- reg : DMA General Status Register, i.e. DGSR which contains + status for all the 4 DMA channels +- ranges : describes the mapping between the address space of the + DMA channels and the address space of the DMA controller - cell-index : controller index. 0 for controller @ 0x8100 -- interrupts : +- interrupts : interrupt specifier for DMA IRQ - interrupt-parent : optional, if needed for interrupt mapping - - DMA channel nodes: - - compatible : compatible list, contains 2 entries, first is - "fsl,CHIP-dma-channel", where CHIP is the processor - (mpc8349, mpc8350, etc.) and the second is - "fsl,elo-dma-channel". However, see note below. - - reg : - - cell-index : dma channel index starts at 0. + - compatible : must include "fsl,elo-dma-channel" + However, see note below. + - reg : DMA channel specific registers + - cell-index : DMA channel index starts at 0. Optional properties: - - interrupts : - (on 83xx this is expected to be identical to - the interrupts property of the parent node) + - interrupts : interrupt specifier for DMA channel IRQ + (on 83xx this is expected to be identical to + the interrupts property of the parent node) - interrupt-parent : optional, if needed for interrupt mapping Example: @@ -70,30 +67,27 @@ Example: }; }; -* Freescale 85xx/86xx DMA Controller - -Freescale PowerPC 85xx/86xx have on chip general purpose DMA controllers. +** Freescale EloPlus DMA Controller + This is a 4-channel DMA controller with extended addresses and chaining, + mainly used in Freescale mpc85xx/86xx, Pxxx and BSC series chips, such as + mpc8540, mpc8641 p4080, bsc9131 etc. Required properties: -- compatible : compatible list, contains 2 entries, first is - "fsl,CHIP-dma", where CHIP is the processor - (mpc8540, mpc8540, etc.) and the second is - "fsl,eloplus-dma" -- reg : +- compatible : must include "fsl,eloplus-dma" +- reg : DMA General Status Register, i.e. DGSR which contains + status for all the 4 DMA channels - cell-index : controller index. 0 for controller @ 0x21000, 1 for controller @ 0xc000 -- ranges : Should be defined as specified in 1) to describe the - DMA controller channels. +- ranges : describes the mapping between the address space of the + DMA channels and the address space of the DMA controller - DMA channel nodes: - - compatible : compatible list, contains 2 entries, first is - "fsl,CHIP-dma-channel", where CHIP is the processor - (mpc8540, mpc8560, etc.) and the second is - "fsl,eloplus-dma-channel". However, see note below. - - cell-index : dma channel index starts at 0. - - reg : - - interrupts : + - compatible : must include "fsl,eloplus-dma-channel" + However, see note below. + - cell-index : DMA channel index starts at 0. + - reg : DMA channel specific registers + - interrupts : interrupt specifier for DMA channel IRQ - interrupt-parent : optional, if needed for interrupt mapping Example: -- cgit v1.2.2 From 03aa254f1e3c3d902cd68763f8abc2387e82b4da Mon Sep 17 00:00:00 2001 From: Hongbo Zhang Date: Thu, 26 Sep 2013 17:33:42 +0800 Subject: DMA: Freescale: Add new 8-channel DMA engine device tree nodes Freescale QorIQ T4 and B4 introduce new 8-channel DMA engines, this patch adds the device tree nodes for them. Signed-off-by: Hongbo Zhang Acked-by: Mark Rutland Signed-off-by: Vinod Koul --- .../devicetree/bindings/powerpc/fsl/dma.txt | 70 ++++++++++++++++++++++ 1 file changed, 70 insertions(+) (limited to 'Documentation/devicetree') diff --git a/Documentation/devicetree/bindings/powerpc/fsl/dma.txt b/Documentation/devicetree/bindings/powerpc/fsl/dma.txt index 05841689c4a3..7fc1b010fa75 100644 --- a/Documentation/devicetree/bindings/powerpc/fsl/dma.txt +++ b/Documentation/devicetree/bindings/powerpc/fsl/dma.txt @@ -128,6 +128,76 @@ Example: }; }; +** Freescale Elo3 DMA Controller + DMA controller which has same function as EloPlus except that Elo3 has 8 + channels while EloPlus has only 4, it is used in Freescale Txxx and Bxxx + series chips, such as t1040, t4240, b4860. + +Required properties: + +- compatible : must include "fsl,elo3-dma" +- reg : contains two entries for DMA General Status Registers, + i.e. DGSR0 which includes status for channel 1~4, and + DGSR1 for channel 5~8 +- ranges : describes the mapping between the address space of the + DMA channels and the address space of the DMA controller + +- DMA channel nodes: + - compatible : must include "fsl,eloplus-dma-channel" + - reg : DMA channel specific registers + - interrupts : interrupt specifier for DMA channel IRQ + - interrupt-parent : optional, if needed for interrupt mapping + +Example: +dma@100300 { + #address-cells = <1>; + #size-cells = <1>; + compatible = "fsl,elo3-dma"; + reg = <0x100300 0x4>, + <0x100600 0x4>; + ranges = <0x0 0x100100 0x500>; + dma-channel@0 { + compatible = "fsl,eloplus-dma-channel"; + reg = <0x0 0x80>; + interrupts = <28 2 0 0>; + }; + dma-channel@80 { + compatible = "fsl,eloplus-dma-channel"; + reg = <0x80 0x80>; + interrupts = <29 2 0 0>; + }; + dma-channel@100 { + compatible = "fsl,eloplus-dma-channel"; + reg = <0x100 0x80>; + interrupts = <30 2 0 0>; + }; + dma-channel@180 { + compatible = "fsl,eloplus-dma-channel"; + reg = <0x180 0x80>; + interrupts = <31 2 0 0>; + }; + dma-channel@300 { + compatible = "fsl,eloplus-dma-channel"; + reg = <0x300 0x80>; + interrupts = <76 2 0 0>; + }; + dma-channel@380 { + compatible = "fsl,eloplus-dma-channel"; + reg = <0x380 0x80>; + interrupts = <77 2 0 0>; + }; + dma-channel@400 { + compatible = "fsl,eloplus-dma-channel"; + reg = <0x400 0x80>; + interrupts = <78 2 0 0>; + }; + dma-channel@480 { + compatible = "fsl,eloplus-dma-channel"; + reg = <0x480 0x80>; + interrupts = <79 2 0 0>; + }; +}; + Note on DMA channel compatible properties: The compatible property must say "fsl,elo-dma-channel" or "fsl,eloplus-dma-channel" to be used by the Elo DMA driver (fsldma). Any DMA channel used by fsldma cannot be used by another -- cgit v1.2.2