| Commit message (Expand) | Author | Age |
... | |
| | | | | | | | | * | | [ARM] pxa: remove keypad register definitions from pxa-regs.h | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: add pxa27x_keypad device and pxa_set_keypad_info() | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: allow dynamic enable/disable of GPIO wakeup for pxa{25x,27x} | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: add MFP-alike pin configuration support for pxa{25x, 27x} | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: separate GPIOs and their mode definitions to pxa2xx-gpio.h | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: integrate low IRQ chip (ICIP) and high IRQ chip (ICIP2) into one | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4868/1: Enhance pxa270 GPIO definitions | Robert Jarzmik | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4830/1: Add support for the CLK_POUT pin on PXA3xx CPUs | Mark Brown | 2008-04-19 |
| | | | | | | | | |/ |
|
| | | | | | | | * | | Orion: orion -> orion5x rename | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | Orion: general cleanup | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | Orion: only map peripheral register space once | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | Orion: move I/O macros out of orion.h | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | Orion: describe physical address map | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: make orion_nand available for all Orion families | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: make ehci-orion available for all Orion families | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: share time handling code | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: share PCIe handling code | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: share IRQ handling code | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | ehci-orion: mbus decode window support | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | |/ |
|
| | | | | | | * | | ns9xxx: let putc autodetect where to write | Uwe Kleine-König | 2008-03-31 |
| | | | | | | * | | ns9xxx: prepare for adding support for Digi ns921x processors | Uwe Kleine-König | 2008-03-31 |
| | | | | | | * | | ns9xxx: add module_is_..., processor_is_... and board_is_... for many machs | Uwe Kleine-König | 2008-03-31 |
| | | | | | | * | | ns9xxx: Use get_irqnr_preamble to initialize base register | Uwe Kleine-König | 2008-03-31 |
| | | | | | | |/ |
|
| | | | | | * | | [ARM] 4887/1: i.MXC family: Separate current platform code | Robert Schwebel | 2008-04-17 |
| | | | | | * | | [ARM] 4876/1: i.MXC family: Clean up | Robert Schwebel | 2008-03-31 |
| | | | | | |/ |
|
| | | | | * / | [ARM] 4852/1: Add timerfd_create, timerfd_settime and timerfd_gettime syscall... | Uwe Kleine-König | 2008-04-19 |
| | | | | |/ |
|
| | | | * / | [ARM] 4981/1: [KS8695] Simple LED driver | Andrew Victor | 2008-04-17 |
| | | | |/ |
|
| | | * / | iop: unconditionally initialize the ATU on platforms known to be 'hosts' | Dan Williams | 2008-03-26 |
| | | |/ |
|
| | * / | [ARM] 4988/1: Add GPIO lib support to the EP93xx | Ryan Mallon | 2008-04-19 |
| | |/ |
|
| * | | [ARM] 4913/1: [AT91] PMC_MDIV definitions | Andrew Victor | 2008-04-10 |
| * | | [ARM] 4907/1: [AT91] SAM9/CAP9 reset reason | Andrew Victor | 2008-04-04 |
| * | | [ARM] 4904/1: [AT91] Pass ECC controller to NAND driver | Andrew Victor | 2008-04-04 |
| * | | [ARM] 4902/1: [AT91] SAM9/CAP9 memory controller header | Andrew Victor | 2008-04-04 |
| |/ |
|
* | | RealView: Add uncompressing support for PB1176 | Catalin Marinas | 2008-04-18 |
* | | RealView: Base support for the PB1176 platform | Bahadir Balban | 2008-04-18 |
* | | RealView: Add uncompressing support to PB11MPCore | Catalin Marinas | 2008-04-18 |
* | | RealView: Base support for the PB11MPCore platform | Bahadir Balban | 2008-04-18 |
* | | RealView: Change the IO_ADDRESS macro | Catalin Marinas | 2008-04-18 |
* | | RealView: Move more device address definitions to board-eb.h | Catalin Marinas | 2008-04-18 |
* | | RealView: Move the UART definitions to EB specific files | Catalin Marinas | 2008-04-18 |
* | | RealView: Move the timer definitions into the EB specific files | Catalin Marinas | 2008-04-18 |
* | | RealView: Move the flash definitions out of platform.h | Catalin Marinas | 2008-04-18 |
* | | RealView: Move the EB GIC definitions to the board file | Catalin Marinas | 2008-04-18 |
* | | RealView: Move the SCU initialisation out of __v6_setup | Catalin Marinas | 2008-04-18 |
* | | Add a prefetch abort handler | Paul Brook | 2008-04-18 |
* | | ARMv7: Add support for the ThumbEE state saving/restoring | Catalin Marinas | 2008-04-18 |
|/ |
|
* | [ARM] 4872/1: Replaces buggy macro in S3C2410 irq include | Davide Rizzo | 2008-03-20 |
* | [ARM] 4869/1: ARM: OMAP: Fix compile for mcbsp | Tony Lindgren | 2008-03-20 |
* | [ARM] 4863/1: AT91: CAP9 USART definitions for early debug | Andrew Victor | 2008-03-20 |
* | Merge branch 'omap-fixes' | Russell King | 2008-03-06 |
|\ |
|