| Commit message (Expand) | Author | Age |
... | |
| | | | | | | | | | | * | | [ARM] 4983/1: S3C2412: Add initial memory controller registers | Ben Dooks | 2008-04-17 |
| | | | | | | | | | | |/ |
|
| | | | | | | | | | * | | [ARM] 4962/1: Introduce standard gpio interface for Scoop2. | Dmitry Baryshkov | 2008-04-10 |
| | | | | | | | | | * | | [ARM] 4961/1: gpiolib support for SA-1100 architecture | Dmitry Baryshkov | 2008-04-10 |
| | | | | | | | | | |/ |
|
| | | | | | | | | * | | [ARM] pxa: V4L2 soc_camera driver for PXA270 | Guennadi Liakhovetski | 2008-04-19 |
| | | | | | | | | * | | [ARM] 5002/1: tosa: add two more leds | Dmitry Baryshkov | 2008-04-19 |
| | | | | | | | | * | | [ARM] 5004/1: Tosa: make several unreferenced structures static. | Dmitry Baryshkov | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4976/1: zylonite: Configure GPIO for WM9713 IRQ line | Mark Brown | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4973/1: Tosa: use leds-gpio driver. | Dmitry Baryshkov | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4972/1: Tosa: convert scoop GPIOs usage to generic gpio code | Dmitry Baryshkov | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4971/1: pxaficp_ir: provide startup and shutdown hooks | Dmitry Baryshkov | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4959/1: PXA: Fix misprint in CICR1_RGBT_CONV | Mike Rapoport | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4952/1: magician: add LCD detection, LCD power switching, update pxafb ... | Philipp Zabel | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4948/1: magician: use htc-egpio to drive the GPIO/IRQ expander CPLD | Philipp Zabel | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4943/2: magician: fix magician.h GPIO header includes | Philipp Zabel | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4867/1: Adds flash, udc, mci support for gumstix F boards | Jaya Kumar | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: remove keypad register definitions from pxa-regs.h | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: add pxa27x_keypad device and pxa_set_keypad_info() | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: allow dynamic enable/disable of GPIO wakeup for pxa{25x,27x} | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: add MFP-alike pin configuration support for pxa{25x, 27x} | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: separate GPIOs and their mode definitions to pxa2xx-gpio.h | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] pxa: integrate low IRQ chip (ICIP) and high IRQ chip (ICIP2) into one | eric miao | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4868/1: Enhance pxa270 GPIO definitions | Robert Jarzmik | 2008-04-19 |
| | | | | | | | | * | | [ARM] 4830/1: Add support for the CLK_POUT pin on PXA3xx CPUs | Mark Brown | 2008-04-19 |
| | | | | | | | | |/ |
|
| | | | | | | | * | | Orion: orion -> orion5x rename | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | Orion: general cleanup | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | Orion: only map peripheral register space once | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | Orion: move I/O macros out of orion.h | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | Orion: describe physical address map | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: make orion_nand available for all Orion families | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: make ehci-orion available for all Orion families | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: share time handling code | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: share PCIe handling code | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | plat-orion: share IRQ handling code | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | * | | ehci-orion: mbus decode window support | Lennert Buytenhek | 2008-03-27 |
| | | | | | | | |/ |
|
| | | | | | | * | | ns9xxx: let putc autodetect where to write | Uwe Kleine-König | 2008-03-31 |
| | | | | | | * | | ns9xxx: prepare for adding support for Digi ns921x processors | Uwe Kleine-König | 2008-03-31 |
| | | | | | | * | | ns9xxx: add module_is_..., processor_is_... and board_is_... for many machs | Uwe Kleine-König | 2008-03-31 |
| | | | | | | * | | ns9xxx: Use get_irqnr_preamble to initialize base register | Uwe Kleine-König | 2008-03-31 |
| | | | | | | |/ |
|
| | | | | | * | | [ARM] 4887/1: i.MXC family: Separate current platform code | Robert Schwebel | 2008-04-17 |
| | | | | | * | | [ARM] 4876/1: i.MXC family: Clean up | Robert Schwebel | 2008-03-31 |
| | | | | | |/ |
|
| | | | | * / | [ARM] 4852/1: Add timerfd_create, timerfd_settime and timerfd_gettime syscall... | Uwe Kleine-König | 2008-04-19 |
| | | | | |/ |
|
| | | | * / | [ARM] 4981/1: [KS8695] Simple LED driver | Andrew Victor | 2008-04-17 |
| | | | |/ |
|
| | | * / | iop: unconditionally initialize the ATU on platforms known to be 'hosts' | Dan Williams | 2008-03-26 |
| | | |/ |
|
| | * / | [ARM] 4988/1: Add GPIO lib support to the EP93xx | Ryan Mallon | 2008-04-19 |
| | |/ |
|
| * | | [ARM] 4913/1: [AT91] PMC_MDIV definitions | Andrew Victor | 2008-04-10 |
| * | | [ARM] 4907/1: [AT91] SAM9/CAP9 reset reason | Andrew Victor | 2008-04-04 |
| * | | [ARM] 4904/1: [AT91] Pass ECC controller to NAND driver | Andrew Victor | 2008-04-04 |
| * | | [ARM] 4902/1: [AT91] SAM9/CAP9 memory controller header | Andrew Victor | 2008-04-04 |
| |/ |
|
* | | RealView: Add uncompressing support for PB1176 | Catalin Marinas | 2008-04-18 |
* | | RealView: Base support for the PB1176 platform | Bahadir Balban | 2008-04-18 |