aboutsummaryrefslogtreecommitdiffstats
path: root/drivers/usb/host/ehci-mem.c
Commit message (Collapse)AuthorAge
* USB: EHCI: AMD periodic frame list table quirkAndiry Xu2010-11-16
| | | | | | | | | | | | | | | | | | | | | | On AMD SB700/SB800/Hudson-2/3 platforms, USB EHCI controller may read/write to memory space not allocated to USB controller if there is longer than normal latency on DMA read encountered. In this condition the exposure will be encountered only if the driver has following format of Periodic Frame List link pointer structure: For any idle periodic schedule, the Frame List link pointers that have the T-bit set to 1 intending to terminate the use of frame list link pointer as a physical memory pointer. Idle periodic schedule Frame List Link pointer shoule be in the following format to avoid the issue: Frame list link pointer should be always contains a valid pointer to a inactive QHead with T-bit set to 0. Signed-off-by: Andiry Xu <andiry.xu@amd.com> Acked-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* USB: add USB EHCI support for MPC5121 SoCAnatolij Gustschin2010-10-22
| | | | | | | | | | | | | | | | | | | | | | | | Extends FSL EHCI platform driver glue layer to support MPC5121 USB controllers. MPC5121 Rev 2.0 silicon EHCI registers are in big endian format. The appropriate flags are set using the information in the platform data structure. MPC83xx system interface registers are not available on MPC512x, so the access to these registers is isolated in MPC512x case. Furthermore the USB controller clocks must be enabled before 512x register accesses which is done by providing platform specific init callback. The MPC512x internal USB PHY doesn't provide supply voltage. For boards using different power switches allow specifying DRVVBUS and PWR_FAULT signal polarity of the MPC5121 internal PHY using "fsl,invert-drvvbus" and "fsl,invert-pwr-fault" properties in the device tree USB nodes. Adds documentation for this new device tree bindings. Signed-off-by: Anatolij Gustschin <agust@denx.de> Cc: Grant Likely <grant.likely@secretlab.ca> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* USB: EHCI: defer reclamation of siTDsAlan Stern2010-04-22
| | | | | | | | | | | | | | | | | This patch (as1369) fixes a problem in ehci-hcd. Some controllers occasionally run into trouble when the driver reclaims siTDs too quickly. This can happen while streaming audio; it causes the controller to crash. The patch changes siTD reclamation to work the same way as iTD reclamation: Completed siTDs are stored on a list and not reused until at least one frame has passed. Signed-off-by: Alan Stern <stern@rowland.harvard.edu> Tested-by: Nate Case <ncase@xes-inc.com> CC: <stable@kernel.org> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* USB: EHCI: split ehci_qh into hw and sw partsAlek Du2009-09-23
| | | | | | | | | | | | | | | | | The ehci_qh structure merged hw and sw together which is not good: 1. More and more items are being added into ehci_qh, the ehci_qh software part are unnecessary to be allocated in DMA qh_pool. 2. If HCD has local SRAM, the sw part will consume it too, and it won't bring any benefit. 3. For non-cache-coherence system, the entire ehci_qh is uncachable, actually we only need the hw part to be uncacheable. Spliting them will let the sw part to be cacheable. Signed-off-by: Alek Du <alek.du@intel.com> Cc: David Brownell <dbrownell@users.sourceforge.net> CC: Alan Stern <stern@rowland.harvard.edu> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* USB: EHCI: slow down ITD reuseKarsten Wiese2009-02-27
| | | | | | | | | | | | | | | | | | | | | | | | | Currently ITDs are immediately recycled whenever their URB completes. However, EHCI hardware can sometimes remember some ITD state. This means that when the ITD is reused before end-of-frame it may sometimes cause the hardware to reference bogus state. This patch defers reusing such ITDs by moving them into a new ehci member cached_itd_list. ITDs resting in cached_itd_list are moved back into their stream's free_list once scan_periodic() detects that the active frame has elapsed. This makes the snd_usb_us122l driver (in kernel since .28) work right when it's hooked up through EHCI. [ dbrownell@users.sourceforge.net: comment fixups ] Signed-off-by: Karsten Wiese <fzu@wemgehoertderstaat.de> Tested-by: Philippe Carriere <philippe-f.carriere@wanadoo.fr> Tested-by: Federico Briata <federicobriata@gmail.com> Cc: stable <stable@kernel.org> Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* Revert "USB: EHCI cpufreq fix"Linus Torvalds2007-08-21
| | | | | | | | | | | | | This reverts commit 196705c9bbc03540429b0f7cf9ee35c2f928a534. It was reported to cause a regression by Daniel Exner, and Arjan van de Ven points out that we actually already have infrastructure in place for setting limits on acceptable DMA latency that would be the much more correct fix for the problem with some Broadcom EHCI controllers. Fixed up trivial conflicts due to the changes to support big-endian host controller descriptors in drivers/usb/host/{ehci-sched.c,ehci.h}. Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* USB: ehci refcounts work on ppc7448David Brownell2007-07-12
| | | | | | | | | | | | Remove atomic operations on the reference counter for EHCI queue heads. On various platforms (including ppc7448), atomic operations are unusable with dma-coherent memory. Signed-off-by: Steven J. Hill <sjhill1@rockwellcollins.com> Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* USB: EHCI support for big-endian descriptorsStefan Roese2007-07-12
| | | | | | | | | | | | | | | | | | | | | | | | | | This patch implements supports for EHCI controllers whose in-memory data structures are represented in big-endian format. This is needed (unfortunately) for the AMCC PPC440EPx SoC EHCI controller; the EHCI spec doesn't specify little-endian format, although that's what most other implementations use. The guts of the patch are to introduce the hc32 type and change all references from le32 to hc32. All access routines are converted from cpu_to_le32(...) to cpu_to_hc32(ehci, ...) and similar for the other "direction". (This is the same approach used with OHCI.) David fixed: Whitespace fixes; refresh against ehci cpufreq patch; move glue for that PPC driver to the patch adding it; fix free symbol capture bugs in modified "constant" macros; and make "hc32" etc be "le32" unless we really need the BE options, so "sparse" can do some real good. Signed-off-by: Stefan Roese <sr@denx.de> Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* USB: EHCI cpufreq fixStuart_Hayes@Dell.com2007-07-12
| | | | | | | | | | | | | | | | | EHCI controllers that don't cache enough microframes can get MMF errors when CPU frequency changes occur between the start and completion of split interrupt transactions, due to delays in reading main memory (caused by CPU cache snoop delays). This patch adds a cpufreq notifier to the EHCI driver that will inactivate split interrupt transactions during frequency transitions. It was tested on Intel ICH7 and Serverworks/Broadcom HT1000 EHCI controllers. Signed-off-by: Stuart Hayes <stuart_hayes@dell.com> Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* USB: EHCI whitespace fixes (cosmetic)David Brownell2006-09-27
| | | | | | | | | | [ ... when you have an editor set to remind you of whitespace bugs ... ] Cosmetic EHCI changes: remove end-of-line whitespace, spaces before tabs. Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* [PATCH] USB: kzalloc() conversion for rest of drivers/usbEric Sesterhenn2006-03-20
| | | | | Signed-off-by: Eric Sesterhenn <snakebyte@gmx.de> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* [PATCH] USB core and HCDs: don't put_device while atomicAlan Stern2006-03-20
| | | | | | | | | | | | This patch (as640) removes several put_device and the corresponding get_device calls from the USB core and HCDs. Some of the puts were done in atomic contexts, and none of them are needed since the core now guarantees that every endpoint will be disabled and every URB completed before a USB device is released. Signed-off-by: Alan Stern <stern@rowland.harvard.edu> Acked-by: David Brownell <david-b@pacbell.net> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* [PATCH] gfp_t: drivers/usbAl Viro2005-10-28
| | | | | Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] USB: kfree cleanup for drivers/usb/* - no need to check for NULLJesper Juhl2005-04-18
| | | | | | | | | | | | Get rid of a bunch of redundant NULL pointer checks in drivers/usb/*, there's no need to check a pointer for NULL before calling kfree() on it. Signed-off-by: Jesper Juhl <juhl-lkml@dif.dk> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de> Index: gregkh-2.6/drivers/usb/class/audio.c ===================================================================
* Linux-2.6.12-rc2v2.6.12-rc2Linus Torvalds2005-04-16
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!