litmus-rt.git - The LITMUS^RT kernel.

	Commit message (Expand)	Author	Age
*	Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jik...	Linus Torvalds	2011-05-23
\|\
\| *	treewide: fix a few typos in comments	Justin P. Mattock	2011-05-10
\| *	Merge branch 'master' into for-next	Jiri Kosina	2011-04-26
\| \|\
\| * \|	treewide: remove extra semicolons	Justin P. Mattock	2011-04-10
\| * \|	update David Miller's old email address	Justin P. Mattock	2011-04-06
* \| \|	Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6	Linus Torvalds	2011-05-20
\|\ \ \
\| * \| \|	libcxgbi: Use flowi4's saddr in cxgbi_check_route().	David S. Miller	2011-05-03
\| * \| \|	ipv4: Make caller provide on-stack flow key to ip_route_output_ports().	David S. Miller	2011-05-03
\| * \| \|	ethtool: Call ethtool's get/set_settings callbacks with cleaned data	David Decotigny	2011-04-29
* \| \| \|	Merge git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi-misc-2.6	Linus Torvalds	2011-05-20
\|\ \ \ \
\| * \| \| \|	[SCSI] qla2xxx: Refactor call to qla2xxx_read_sfp for thermal temperature.	Joe Carnuccio	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Unify the read/write sfp mailbox command routines.	Joe Carnuccio	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Clear complete initialization control block.	Andrew Vasquez	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Allow an override of the registered maximum LUN.	Andrew Vasquez	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Add host number in reset and quiescent message logs.	Saurav Kashyap	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Correctly read sfp single byte mailbox register.	Joe Carnuccio	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Add qla82xx_rom_unlock() function.	Chad Dupuis	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Log if qla82xx firmware fails to load from flash.	Chad Dupuis	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Use passed in host to initialize local scsi_qla_host in queue...	Madhuranath Iyengar	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Correct buffer start in edc sysfs debug print.	Joe Carnuccio	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Update firmware version after flash update for ISP82xx.	Saurav Kashyap	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Fix hang during driver unload when vport is active.	Arun Easi	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Properly set the dsd_list_len for dsd_chaining in cmd type 6.	Andrew Vasquez	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Fix virtual port failing to login after chip reset.	Saurav Kashyap	2011-05-17
\| * \| \| \|	[SCSI] qla2xxx: Fix vport delete hang when logins are outstanding.	Arun Easi	2011-05-17
\| * \| \| \|	[SCSI] hpsa: Change memset using sizeof(ptr) to sizeof(*ptr)	Joe Perches	2011-05-17
\| * \| \| \|	[SCSI] ipr: Rate limit DMA mapping errors	Anton Blanchard	2011-05-17
\| * \| \| \|	[SCSI] hpsa: add P2000 to list of shared SAS devices	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: do not attempt PCI power management reset method if we know it w...	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: remove superfluous sleeps around reset code	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: do soft reset if hard reset is broken	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: use new doorbell-bit-5 reset method	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: remove atrophied hpsa_scsi_setup function	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: clarify messages around reset behavior	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: increase time to wait for board reset	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: factor out irq request code	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: factor out cmd pool allocation functions	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: wait longer for no-op to complete after resetting controller	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: do a better job of detecting controller reset failure	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: delete old unused padding garbage	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: remove unused parameter from hpsa_complete_scsi_command()	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: add readl after writel in interrupt mask setting code	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] hpsa: do readl after writel in main i/o path to ensure commands don't ...	Stephen M. Cameron	2011-05-17
\| * \| \| \|	[SCSI] be2iscsi: update version	Jayamohan Kallickal	2011-05-01
\| * \| \| \|	[SCSI] be2iscsi: fix chip cleanup	Jayamohan Kallickal	2011-05-01
\| * \| \| \|	[SCSI] be2iscsi: fix boot hang due to interrupts not getting rearmed	Jayamohan Kallickal	2011-05-01
\| * \| \| \|	[SCSI] arcmsr: simplify assumptions in dma_alloc_coherent()	Tomas Henzl	2011-05-01
\| * \| \| \|	[SCSI] arcmsr: simplify some double loops in sleeping functions	Tomas Henzl	2011-05-01
\| * \| \| \|	[SCSI] bnx2fc: setup em for npiv port	Vasu Dev	2011-05-01
\| * \| \| \|	[SCSI] iterate over devices individually for /proc/scsi/scsi	Jeff Mahoney	2011-05-01